Search results

Hello all! My apologies if I have posted in the incorrect location. I am planning and budgeting the cost of building/purchasing a heavy lift multi. Its main use will be AP and Videography and will need to be able to comfortably carry a brushless gimbal for dslr and the camera and lens (Canon...

Here are details of the spring northern meet in Yorkshire, UK. There will be workshops, presentations and plenty of flying inside and out. All are welcome! http://www.fpvhub.com/index.php/topic,9871.135.html Sent from my iPad using Tapatalk HD

Hey guys, my hexa was up and running and flying with the AeroXcraft landing gear and go pro gimbal. I've just changed from 8" to 10" props and from 4S 5000 mah to 3S 5500mah lipos. My all in weight is 2300g with GP2 and FPV. I'm not sure what to set the gains at. Are there any recommendations...

Hey guys, maidened the hexa today. Didn't go well. The hexa was drawing way too much current. 30A @ half throttle. The independent lipo voltage alarm was going off as well. I've since checked the lipo it read 16v and 75% capacity! I was in the air less than a minute. I'm running stock dji...

Ok, its been a fair while since Ive been on here. Im in the process of upgrading my F450 to a F550 Ive purchased the AeroXcraft landing gear and Go Pro Tilt and Roll Gimbal. Which you can see here:- http://www.aeroxcraft.com/index.php?main_page=product_info&cPath=13&products_id=20 and here:-...

This is my test flight today after repairing the quad after the nasty crash I had in November. Theres something not right with it, but Im not sure what. It yaws to port (left) slightly and drifts to port and aft quite drastically. Once all the GPS satellites had kicked in I think it seemed to...

Well, after way too much time away from home, I'm finally back and the quad has been repaired, I think. 1x arm, 1x esc, 1x motor, 1x 8" prop and 1x TeamFTP leg and some careful testing in the Naza Assistant and I think I'm ready to go. I just need to refit the Go-Pro and wait for some good...

Hey guys, I have a querie. Is it possible or recommended to use the servo channels 1 to 7 of the Futaba R6208SB when you are using the S-Bus to connect to your Naza? All flight controls at this moment in time are being run through the S-bus so I have just 1 cable connecting the receiver and...

I saw this today on the BBC News website. http://www.bbc.co.uk/news/business-20200856

Given my recent incident with the ground, I'm left with a motor covered in mud. Does anyone here know how to strip down and clean DJI motors? I will probably be purchasing a new motor anyway, but I believe it would be adequate as a spare. Sent from my iPhone using Tapatalk

Well it must be a day for crashes! The first flight of the day not 30 seconds in the air and quad decides to run off! It was heading to the woods and I knew I wouldn't find it again of it went in their so I did the only thing I could think of.... I ditched it! I managed to find most of the bits...

Here's footage of me and my mate having a quick fly yesterday. It must have been blowing 20 mph but the Naza and GPS seemed to cope quite well, although the video is a bit lopsided in parts. It was an enjoyable afternoon anyway, even considering I had a little crash (it's not on this vid)...

Yay, after hmm-ing and ahhh-ing ive finally bitten the bullet and ordered an f450 with Naza and GPS as my first multicopter.... my first rc aircraft excluding my little mqx. I was going to go for a TBS but after some good advice from Quadcopters I went for the smaller and cheaper starting point...

Ok, I've got a future project in mind which I would really like to use droidworx airframes on. The airframe would need to be able to carry a minimum of a 2 axis camera mount system, possibly the Z15 or a PH system and an NEX 5n, I know a lot of airframes can carry that at this moment in time...

Ok, so Ive been looking into the forums for a while now and trolling the internet trying to get as much information I can about MRC's before I end up purchasing. Ive pretty much decided to go with the DJI F450 or F550 kit with Naza+GPS and bits 'n' bobs (Ive got a £1.5k budget so this could...

Hey Guys and Gals (if there are any), I was wondering if anyone was near the Barnsley/Sheffield South Yorkshire area? Or, if anyone knew of any local clubs? Im a complete novice to whole RC Heli / MRC thing and was wanting to meet up with people to see what the crack was and to pick brains...

Hey Guys and Gals, I just wanted to say Hi, Im a complete Newbie to Multicopters/Drones, although I have some experience with Remotely Operated Vehicles. I was wondering where exactly to start. I don't own any equipment as yet, but I do have a firm idea as to where I want to go with it...