Search results

Another thing that can cause this on some programs is running software on some of the smaller notepad computers that have odd display resolutions. Sometimes they simply don't have the resolution to allow all of the program window to display. If this is the case you may find you cant drag the...

As per the others, my GoPro and GPS are both mounted on the front of my F450 and there isnt any interference to the GPS reception Check what other wiring you have passing near the GoPro as that may pick up radiated interference and re-radiate it

Therein lies the problem in Aus. Not enough requirement to stock them.

There is a local (Australian) Graupner supplier but they have a very limited list of props.

You could try to rebind it with less throttle and see what happens. Mine was set to about 40% and it landed slowly with a delicate touchdown. During the landing the throttle control had no effect so it was in complete control while it remained in failsafe mode. The only thing the instructions...

Have you set a switch on your TX to select the Failsafe option on the assistant? What I did was to set a failsafe setting that I could switch to from the TX (which allows me to select RTH at any time in flight). I then bound my RX with all sticks centerd, the throttle set to around 40% and the...

Finally tested my F450 with the new Naza GPS this weekend. I'm quite impressed. The wind was gusting past 20 knots at times and the quad just sat there angled into the wind and moved less that 1 foot horizontally. The gusts affected the altitude slightly but it always managed to correct itself...

Ordered my Naza GPS rom MultiWiiCopter in Aus on Tuesday night (as soon as the website showed stock) and its now waiting for me to collected at my PO Box today. That's fast service and there are still those who pre-ordered theirs from overseas who are still waiting for shipping notification...

You can try MultiWiiCopter.com in Australia. He has just listed them in stock as of last night (June 12)

Your proposed situation should be no different to flying alongside another RC operator. Its only a problem when mixing RC and video systems within the same band as the video system is usually wide band and poorly filtered.

I just eyeballed mine and its spot on stability wise. Hovers hands off.

Hi Stupest There are some photos of my quad here http://www.multirotorforums.com/showthread.php?2886-Show-us-your-FPV-Multicopter/page2 If you want more details I'm happy to take some more in detail. Ian

I haven't installed the new firmware yet (I was going to wait for the GPS). Once you do the CNC, do the other two motors spin up when you advance the throttle. I believe there is an setting where you can control the idle speed of the motors at CNC and if you set it too low some motors may not...

For those not following the threads on other forums, the Naza GPS appears to have been successfully tested in Aus and is arriving at dealers right now. We should start to see reports from new owners over the next week or so. Looking forward to getting one.

My Naza is a stable as I could ever want it. When I lift off it seems to tilt slightly towards the left but stabilises straight away. It then hovers dead steady as if its on GPS position hold. When I first built it, it used to wander a little bit and I found it was susceptible to changes in...

Yes I wrote a small X on my dodgy pack with a permanent marker so I could keep an eye on it. So far it's holding up well.

I use a single 5.8 GHz TX and have a video switch. I use a GoPro generally but I can switch to a Sony super HAD camera for closer viewing and improved low light visibility.

I've been using the GpPro Hero 1 for FPV for 6 months and haven't noticed any latency. It its there is isn't affecting my ability to fly in FPV mode. Mine is set to 720p.

You may be successful if its just you, but I think the biggest issue starts to arise if you're flying with others who are also using the 2.4 GHz band for RC. As you add signals to the 2.4 GHz band the chances of interference to everyone increases quickly.

Ive been using the Turnigy Plushes for a number of years in everything I fly but my flamewheel and I've never had a failure. This includes around 25 fixed wing models from park flyers and warbirds to EDFs as well as a home build tricopter. Yes they're often out of stock at HK because they're so...