Search results

  1. T

    DJI S800 Pics

    320kV and 15" CF props too. Uses 6S up to 15,000mAh. 16min on 10A per their ad. http://www.dji-innovations.com/minisite/S800_preorder_en.html
  2. T

    DJI S800 Pics

    My guess is that this is a pre-production test mule using the OPTO esc's. From what I understand in the production unit the esc resides under the plate shown in picture three at the end of the arm under the motor.
  3. T

    Should I swap CC board for Naza?

    It is like the question that I asked myself when I went from ArduMega to the DJI products. I kept a Mega board and a Jussi 9DOF sensor board in case I decide to play later. I now own a WKM, a Naza and a WKH for my Trex550E. If you can afford it, keep one CC board and get the Naza. I don't...
  4. T

    DX8 mix - help needed

    That is how I have my 9503 set up. I think I am at -53 but as you said, it will vary with each set up.
  5. T

    Naza throttle setup ?

    Yes in Assistant the throttle showed 0. At that point, the Naza took over and landed the quad. As far as Intelligent mode goes, I am not sure if it plays a roll in LOS.
  6. T

    Naza throttle setup ?

    Yes with the Naza it just lands. Just like it does when you hit the second battery threshold. To be honest, with the Naza, I am not sure if you really have to set up Failsafe in the receiver. I have used a AR6XXX and it only has SmartSafe. I turned off the Tx and it landed. I switched the...
  7. T

    Naza throttle setup ?

    I have been in situations where the multi was at a distance and I lost orientation. I switched to Failsafe mode and the craft returned to home and landed. It has saved my butt and my multi on several occasions. The manual states to set the throttle above 10% in Failsafe. I choose to set mine...
  8. T

    DX8 mix - help needed

    I have a Dx8 in addition to my JR9503. I will play with it and post pictures of the set up screens later today. Still finishing up my F450 for FPV with my Naza and my F550 with the WKM and Data Link. I need to do some wiring for the Eagle Tree OSD Pro and Logger with GPS.
  9. T

    DX8 mix - help needed

    This is on a JR9503 but the screens and set up are similar. My Gear channel is set to the Fmode three position switch. Hope this helps.
  10. T

    DJI Zenmuse gimbal and S800 Spreading Wings preorder

    16 minutes with 10,000mAh 6S and 20 minutes with 15,000 mAh 6S. http://www.dji-innovations.com/minisite/S800_preorder_en.html The 20 minute was from a previous announcement. DJI is selling a 15,000mAh 6S.
  11. T

    Naza throttle startup speed

    At this point, the answer is no. If you are using 10" props with 4S, you might want to drop down to 8" props.
  12. T

    Mikrokopter Mikrokopter Firmware Update .88

    A friend of mine told me it was supposed to be out last Monday. Obviously he was wrong. Maybe it is next Monday. Kind of like free beer tomorrow, tomorrow.
  13. T

    Naza throttle setup ?

    Dave, the manual says to set your transmitter throttle at no less than 10% for failsafe. I set mine around 50% but that is my choice to do so, which is above what DJI recommends. Better to be safe than sorry. When I switch off my Tx the slider goes to failsafe and all the channels are...
  14. T

    DJI Zenmuse gimbal and S800 Spreading Wings preorder

    Heinz, you are correct. Sorry for my misinformation. Thanks for correcting me.
  15. T

    DJI Zenmuse gimbal and S800 Spreading Wings preorder

    No, it says on the form to make payment to pre-order@dji-innovations.com. If you send it to sales@dji-innovations.com they will have nothing to match it up with. I also remember that you need a pre-order number to reference when you sent payment. Again a tracking issue. If you have not...
  16. T

    Flamewheel 450 with Naza - erratic flying problems.

    Exactly how hard did you hit the house? Is it possible that you may have damaged the Naza? You have 3 gyros plus 3 accelerometers and a baro sensor. All of which are very sensitive sensors. The are well isolate from most vibrations and minor crashes but if you had a major biff and nothing...
  17. T

    Hot Rodded my f450

    I like what you have done. It looks great. I have my F450 loaded down right now with the WKM and Data Link. I am thinking of moving that set up over to the F550 and use the Naza along with my vTx with OsdPro and GPS. 10" Graupners with 4S should be killer. Thanks for sharing.
  18. T

    WKM stability in GPS/ATT not as good as ATT mode

    3S on the F450 and 4S on the F550.
  19. T

    WKM stability in GPS/ATT not as good as ATT mode

    Thanks, Andy. That helps. In your case with a larger, heavy hexa, I actually would raise the vertical. You can play with the disturbed setting. It effects the strength of the GPS lock on positioning. At least that is my understanding. As a point of reference, I have both my F450, fully...
  20. T

    WKM stability in GPS/ATT not as good as ATT mode

    Could you post your current gains? That would give me a better idea how you might adjust. Also what size copter are you flying?
Top