Search results

You want to wire the Naza VU to your harness. The VU supplies the power to the Naza. You should remove the red wire from the esc's after you have calibrated them.

Ken, that is good to hear. I started my upgrade on Sunday, but my diversity board is giving me fits. I know what I need to do and will fix it tonight. It has been blowing like crazy in Las Vegas all weekend long. Fortunately I am going to go fly Friday, got it off from my new job. I am...

Works on my ATT wifi hot spot using a Sierra Wireless modem.

Steve, I have done it both ways. I currently have my GoPro mounted inverted on a plexiglass piece under the F450 tab. I have the mount slanted down a few degrees, two washers under the front screws. I don't get the props in view. Here is a video that I did while testing props and mounts. I...

Nosedive, sorry I do not.

They are round and a tight fit on the motor. They hold well with just the nut. Be careful when holding the prop while tightening the nut. I cut my finger on the prop. They are very sharp.

Thanks Boris. I never noticed that relationship.

Actually it is not that odd. If you keep the 10" props on and have a very light craft, when you arm the motors at idle, it could get light on the skids.

You will also see this if the Sens lead is plugged into the wrong port. You might want to check that. I switched it once and was scratching my head for a while.

I test fit a pair of 11" graupners and there was a 1/8 inch overlap on my F550. I would not try them. Your craft, your choice.

Well I am going to try it. I have been a crash test dummy before. I was happy with .82 but from what I have heard about .86, how bad can .88 be? Yea, I know but shouldn't this version fix some of the .86 problems?

On the AR8000 the negative lead is on the top and the signal on the bottom.

Man that sucks! It would be nice if Maytech would have alerted everyone with that incompatibility. What other motors are they incompatible with?

I just finished moving my Naza to my F450 and my WKM to my F550. I set my F450 up for FPV. Here are some photos. I am using my GoPro for video and an Immersion 600mw 5.8 vTx. I have the Eagle Trees eLogger v3 and OSD Pro connected as well. Standard F450 with a P-Glass plate fastened to the...

Just trim the tabs on the side off and round the edges a little and they will fit fine. The AR6XXX don't have the same issues because their pin mount is different. Just be careful that you don't trim all the way down to the connector or switch to JR/Spektrum leads.

You have to trim the tabs off the side of the three lead plug. They will work. Be careful that you don't cut down to the lead.

Delivery limited to a 2Km radius.

...

You are like Waldo, I see you everywhere. Very nice Video, even the Plank parts.

For Lipos, I am using the Turnegy NanoTech 3S 2650mAh and I am getting 8+ minutes of flight time with a GoPro. You have the option to use a 4S lipo with the 8" props. I use 4S 4000mAh on my F550 hexa and get about the same flight times.