Search results

same one you got but i bail all the unnecesary wires.. it has +12, -12, signal

everything emits some, it's just a matter if it conflicts with the rest. a big killer is cameras,,,, on long range fpv rigs we use big rigs to seperate all this stuff to make it better, nothing cures rf like shielding the offender, after that the best next move is seperation

it didn't take much but does still hang the frame up a tick...

it is true with anything that transmits rf that you can't take the antenna off.... if happened it burns out the amp and your vtx turns into a 25mw that takes a ton of vigilence to make work at all.... Again, if you remove it from the rig, wire it up so can be handheld, will tell you if the...

I would move the vtx top side of the plate and get rid of the extension,,, this isn't that easy especialy with 5.8..... if the vtx was ever powered up without an antenna, that might be fried..... only way to see a number as in good or bad is the immersion rf analyzer, but for sure 5.8 can not...

heres those headtracker gimbals... http://www.hobbyking.com/hobbyking/store/__51068__Fatshark_3_Axis_Pan_Tilt_and_Roll_Camera_Mount_System_Supported_By_Trinity_Head_Tracker_.html

I had to trim the pcb a tad..... i tried moving over to the tbs 69 on later builds but i'm back to these again.... tbs69 pzo513 seawolf pixim

hobbyking has em

it's a long shot but try "off hollywood"

we get attacked by seaguls all the time.....

if your only option is 1080p, that would be on 24p cinema system speed.... 1080i is only on 59.98hz..... and the live output has to be down sampled to 1080p.... 2 spots to set dazzab, is the system speed on 25 hz? you guys pal?

you would need to build or buy a small servo gimbal for head tracking..... there available at the fpv stores like readymade. the only type i've ever used is non cased type,,,,, you don't need a case, just weighs more....

I'm running gear in a cage on the ground for accelerated longevity testing, uses 220 30 amp service.... 100 lbs

I have it too.....go to lens, no ios, it's only downside. Got a 77mm rocketfish nd filter that came with a 72mm adapter, that adapter goes right over the existing hood, but makes 9mm or less vignette.... it's not much for low light but sure is crisp, the zoom on it is very minimal,,,, to...

you have two ways to measure your IR, either through the main plug that shows the overall ir including the plugs resistance or the individual cell ir with the balance plug in..... alot of new cells i see come 2-4 on individual cells, 30 ish on the tap. i start watching with retirement in mind by...

haven't done this yet but are gearing up to run prolonged flight testing to get accelerated life expectancy.... got one badass power supply to do it, eltek valere 24/48v 250 amp

the kopterworx ones don't do it either.....

in general we use the c rating to ensure enough energy supply.... after that i try making sure one pack on 2 pack rigs can support the system in case it's flown with one pack and to not get into brownouts. When you get a nice charger it shows ir, that is the only thing that matters with a lipo...

the best packs are fresh ones.... generally speaking the expensive packs outlive there lifespan on shelves waiting to get sold.... cheap ones like hobbyking are made frequently..... high c rate is a higher quality pack, but most of the polymers inside are the same for the most part. i steer...

depends on the firmware version.... look at info and see if it shows each piece. the new firmwares have it