Search results

yea, i soldered my controllers back on. I've replaced the servo alot, doesn't do hard landings very well. Seen everything from stripped servo gears to sheared output shafts.

pretty sure that pcb in there stops a servo when it binds.... try opening up the retracts more at the linkage

I have two pairs of the normal non coax versions and they both work perfect with that new spektrum servo.... You have to get that slip compression thing on the servo just right so they open and not slip....

.2 aint working,,, ok

Mhmmm gone through a hundred 12", 13", 14", 15", 16" 17" 18", 28" and every single last one of them appreciated a run across a static magnetic balancer....

there still not very close

that's the main difference in a lite vs. v.2..... the imu isn't heated so they misbehave for a bit till they warm up. i used to use manual to take off then once was overhead i'd flip to atti, depending on how your propping is it can fall so you gotta raise the throttle to mid stick, it'd go up...

I've walked up to cell antennas in 2 cities here in the states and both had labels on them with 2500mhz frequency...... and these were always there. we never had any problems....you should buy an 8fg if your gonna fly a2. the last one i got was $400 but there discontinued so maybe a used one...

on a 5.8 system of any brand it WILL DEGRADE performance

that gap in a motor is caused from breaking a race inside the bearing. The track the balls roll around on. usually happens when a motor hits something other than air or when you run one really hard. sometimes is just in the motors dna.... keeping props balanced helps mitigate it from happening...

it's back.... a log of a flight with a red epic brought it back, no idea whats doing it. wind is one of the few things that seems to be there when i'm getting this. Wonder if my mast on the puck is moving...... it's bolted down http://log.xaircraft.com/report.htm#2014_07_12_172258.750_73.1.01.25

no i haven't... gotcha

the gh3 will do stills in hand while filming if you use a mode other than movieM and start the filming with the movie button on the back,,,, then hitting the trigger snaps pics.. zen doesn't treat it like that?

i don't know about the new dx6 but i'm guessing your saying it has a one wire now like sbus? i haven't seen a setting in naza to use it yet so make sure it works at al yea, it takes a 8 channel to switch cams on a disco using a remote gain and tilt control..... even on sbus, it takes 2 wires...

with gh series cameras the M with a movie icon in it makes the trigger take a movie, any other setting like M, S, A etc the trigger should take a still. I don't have zen so i might be wrong, but the camera operation might be the prob,,,,

aerial mob arms.... we draw 15 amps flying along 40 mph.... can carry 8000 mah doing it.

hmmmm, well today it's back to normal. i lowered the gain so apparently it was on the edge or this things just being that way http://log.xaircraft.cn/report.htm#2014_07_12_011318.557_72.1.03.23 it's flying amazing, can't wait to stretch it's legs

btw, any crash that'd jepordize any arm you would prefer the arm breaks than the pcb it's bolted to..... that leads to fires, problems, etc. trying to say our arms don't stop the breaking from inexperience.... but they do make it fly better, longer, faster and in way more control

the latest kit is a bolt on replacement,,, has spare parts so if you did crash you just get a motor mount, inner frame mount, tube, etc. I believe the kits today are $119 for all four, the next kits in a month are under a hundred, have hardware to also coax, or to bail the landing gear all...

yea,,,, it has vibe iso