Search results

Get the green one. http://vibrationmounts.com/Store.asp?Page=Products8.htm Not cheap.

The GoPro cameras are a known source of interference. I would start by removing or turning off your camera and your FPV equipment. Does it do it then? No, add one system back in and test again. Continue until you find the problem.

I use a JR9503 with either an AR8000 or an AR7010. Plug your Aux 1 into the U channel, and Gear into X1 and Aux 2 into X2, the V-Sense goes into X3. Enable the Fmode in the menu for your mode switch. Your Aux 2 switch now controls IOC and the Gear controls Failsafe. If you need gimbal tilt...

I fly helis as well. The DJI products were not set up like this in the beginning. You could use throttle hold and the motors started when you increased the throttle. There was a small but very vocal group that demanded DJI add the feature. DJI finally did so about the third version of the...

Andrew, DJI needs the hardware ID to supply the new S/N. I had a delay getting mine when I transposed a number on the ID and the new S/N did not work. It was easily correctable, it just took some extra time and emails. In your original email to DJI did you give them the ID or did you not know...

I have a similar set up only I use the 8" props with 4S. If I fly 10", I switch to 3S. When i arm, it is pretty much a simultaneous motion with both thumbs. I move the rudder to the right, the throttle is already at the bottom, and the right stick to the lower left corner. When the motors...