Search results

Hey Ken, Get well soon. Ed

I cannot compete the revue with a video, it was way to windy today. Here are my impressions. The case is great and the video monitor is very usable, is it top of the line, no but it works for FPV. I don't care if it has the highest resolution, I can see my video output. I received the kit...

I live in Vegas and hope to crash the NAB. It may not happen but I would love to be able to do it. I am not contacting my wife's ex, a former broadcaster, to do it however. It will be by my efforts. Anybody attending that would like to assist me with credentials, I would gladly accept them...

Andy, sorry to hear about your experience. It is not typical of the normal Naza owner. Have you contacted your dealer for warranty repair or have them do an investigation into what is going on? If they are unresponsive, I would contact DJI directly.

The GCU has an Analog video out. Plug in there and follow the wiring for the vtx you should be fine. I use the iOSD so I have an additional piece of hardware in-between.

You can route the output from the Zen to the DJI video down link. Since the down link has the Tx and the Rx all you need is something to output it to, goggles, monitor etc. As far as the Dx5, it depends on what you want to control. You will be limited by the number of channels. It depends on...

Maiden complete in 20 mph winds. Now to finish the write up.

Does that include any receivers?

I would check the connections between your motors and escs. It was flying fine for a while. However sometimes the heat created in flight can loosen connections. I also noted that you got one red flash right before you landed. Loss of GPS signal??

It does. This build is a first for me. Simon K esc's CC3D controller. I will post the complete review soon.

My Fn'F came with a wiring harness that I modified and used.

I tried to edit the reserved posts but it would not allow me to do it. I will start again here. I am almost finished with the build. I would like to thank IrisAerial for his help along the way. I have had some questions and suggestions along the way and he has been more than helpful at all...

My initial thoughts are that you will be above the max AUW spec'd on the S800 of 7Kg. I fly 2x5000mw 6S and can get 15-18min without gimbal, 10-12min with. I do not have retracts so I cannot compare there.

DJI has always been a fair company with me and the fact that they stated that they have a 2 year guarantee on all their products is evident of that. I hope that they are able to solve the problems that you are having. I have found that the flight data recorded on the iOSD can be very helpful...

Personally, I would contact your dealer. What you are describing is not normal. I have never had your issue with the two Zen's that I have owned.

You are missing the point. There are times that a small craft is desirable to a big hex or octo for professional shooting. In those cases, having a gimbal that is capable of Zen like stabilization is optimum. The camera is capable of shooting video that has been used in the past for...

To use this controller you need some knowledge of the code that goes into it. MultiWii Arduino. For someone one new, I would not recommend it. You would be better off getting a KK board than deal with the programming. The CC3D is a better board and the interface is much more user friendly...

Per DJI, they will be available tomorrow.

Remember you also need a WKM to make the Zen work even it it is not your Flight Controller. It adds to the cost by a third.

If you look at the manual it states it could be IMU loss of signal. I would be concerned as this is not normal behavior especially with a ZEN and camera onboard.