HI HexaCrafter
Thanks for the help. I understand exactly what you are saying. Are you saying that the "real" failsafe value that you store when binding is hover throttle or landing throttle? If you select altitude return home as fail safe mode it a hover throttle value to able to safely keep...
I have a new Wookong system that I installed and setup and it flies nice. I use 5.20 firmware as I believe its truly the last reliable firmware. It flies very smooth and stable in GPS, ATTI and manual modes. I have been reading and researching how to properly setup the failsafe correctly. I...
Question for all you inspire owners. I just got my inspire and notice there is really no way to put the lipo battery in storage mode easily. You either have to do a trickle effect or essentially fly it down to 60% capacity. This is pretty inconvenient when you might take 5-6 batteries on a shoot...
Thanks for the reply. I found the problem. I wired the motors 1-8 counter clock wise instead of clockwise. I was assuming it was the same direction as Mikrokopter.
Sorry I don't think my issue was described clearly. I can reverse the channel in the radio or simple switch from norm to rev however that doesn't change what I am seeing in the assistant software where it moves from the center to one side of the roll. From my understanding when the slider...
Is anyone using a Wookong or A2 with the graupner PPM signal? I am using a MX20 and have one small question that is baffling me. I have a new install with Wookong and I am testing the copters response controls with the copter weighed down by sand bags with just a little bit of slack so I can...
I am trying to calibrate the compass with WooKong and I having issues trying to get it to go into calibration mode. I read a bunch of threads and seem to get conflicting info. Right now my control switch is setup like this
GPS
Manual
ATTI
I start out the switch in GPS and then switch to...
I have a brand new Wookong M that I am just about finished with the installation but there's one thing that I can't figure out. The software and IOSD are reading my 6S battery fully charged (25.1 volts) as 17.9 volts. When I go try to recalibrate it, the voltage doesn't change regardless if I...
This is my first DJI install, and I have a rather simple question.
I have everything wired up, and communicating through my laptop. I installed 5.20 firmware with 1.36 software and I calibrated my TX. I have registered with the site as well. However I don't see any selection to see the advanced...