This is my first DJI install, and I have a rather simple question.
I have everything wired up, and communicating through my laptop. I installed 5.20 firmware with 1.36 software and I calibrated my TX. I have registered with the site as well. However I don't see any selection to see the advanced options. In the setup PDF it refers to basic, advanced, and viewer options and I don't see anywhere that it allows me to see these options.
Here's what I am seeing on the software screen
Under tools
Flight limits
Firmware upgrade
Disabled all knobs
Check for updates
Under About
Info
Error Code
Language
On the side menu's I see
Mounting
Motor mixer
TX calibration
Auto Pilot
Gimbal
Voltage
Any ideas?
I have everything wired up, and communicating through my laptop. I installed 5.20 firmware with 1.36 software and I calibrated my TX. I have registered with the site as well. However I don't see any selection to see the advanced options. In the setup PDF it refers to basic, advanced, and viewer options and I don't see anywhere that it allows me to see these options.
Here's what I am seeing on the software screen
Under tools
Flight limits
Firmware upgrade
Disabled all knobs
Check for updates
Under About
Info
Error Code
Language
On the side menu's I see
Mounting
Motor mixer
TX calibration
Auto Pilot
Gimbal
Voltage
Any ideas?