ed, if you go that route. make sure to land by the time it says 880... it is easier to put in the amount you want to use, not whats actualy onboard cause then you land at zero and alot of osd's start throwing warning when that gets near. if you run all 4400 mah out, your packs will be done
Over the last 4 years i've thrown litteraly thousands of dollars down the drain mixing a charged and not charged pack..... the last time it was my 700 size md 500, took off, felt kinda heavy, got a couple laps in, about 300 yards out she got really heavy and the ground was coming up iminent. I dropped the collective but by the time i seen it move down it was too late. i flared and gave it full collective. Luckily when it hit it smashed down to the floor and kept level without blade striking the ground, but it litteraly destroyed a $4,000 model in the blink of an eye. I had been hagling with a guy that had me down to $3600 the week before,,,, shoulda sold it
forced LVC's suck. That's why i'll never let naza control my voltage shutoff
on the upper end this is good
http://media.hyperion.hk/dn/sentry/
i use this
http://www.hobbyking.com/hobbyking/store/__10952__Cell_Log_8M_Cell_Voltage_Monitor_2_8S_Lipo.html
when you run packs like this,,,, it's known as 2p...... like the front of a pack will say 3s1p,,,, two parralel is called 3s2p or in 4s, 4s2p....... that's how a guy gets alot of amp handling without buying big fat high c rated packs.