NAZA Lite problems

[Treg]

I can not get the assistant to connect to the MC, on start up 1 get only 3 green lights at the end then fast yellow flashing. When I hook up to the assistant I get green light but I get the MC power On red light. I have other NAZAs that work great, can't seem to get this one to work, any help will help?

 

[kloner]

it sounds like the pmu is bad.... can you hook it to another nazas pmu and see if that fixes the problem?

 

[Treg]

I got it to communicate with the assistant and all setting are fine now except RTH will not activate, and I can not power up the motors, I still get only 3 greens on start up.

 

[Tahoe Ed]

No RTH means no GPS.

 

[Treg]

I forgot about that thank you I just haven't hooked up the GPS yet. But I still can't arm the motors and only 3 green lights on start up.

 

[kloner]

go to the rc setting window and make sure left stick is left, forward sticks makes it see forward, up throttle makes it increase, etc. then calibrate the naza to your radio.....

 

[Treg]

Thanks kloner, but I found the problem with the motors, (simply a bad jumper throttle cable) but I still get only 3 green lights at start up, not sure if that is a problem or not.

 

[kloner]

i can't remember the exact light sequence from the latest firmwares, but if you move the flight mode switch to manual, your not gonna see continuous flashing, atti should show a double flash yellow, gps mode will show a double flash green, waiting for gps signal gives you red flash with either no other flash in man, red/yellow in atti, red/green in gps till the gps locks in, then you'll get this long green flash when it locks gps and sets return to home position, then red goes away

 

[Treg]

I am getting all the right light signals as far as atti-gps-manual-fail safe-rth, just not the 4 green on start up, I have 3 others 1 NAZA-M V1 and 2 NAZA-H and they all give the 4 light ? the manual says it should have 4 green at the end of start up, if not to contact them which I did just waiting for an answer that could take some time LOL but I have to return 1 defective motor to 3D Robotics, which is in your town.