Search results

Great location mate! I would do a bit of colour correction as it is a little flat. Possibly a little too long? Superb job otherwise!

I thought it would be a direct mount to the S1000? Just clip on and go. At least that's what I heard from a bloke down the pub...

Awesome stuff!

I don't think the GPS puck is your problem to be honest. Sounds like a transmitter setup thing to me.

As above, two in parallel. Always good to have redundancy, it's not like you can glide home! :nevreness:

Just out of interest what equipment are you using? Frame, motors & ESC etc. You mentioned the 'I' configuration so hoped for clarity.. And were you using this WKM on another aircraft before, maybe some old settings are still there?

Hmmm, I'm not sure. At least it's flying well! So it is just in the assistant program that the throttle drops to 0%? Are you flying in HELI mode? I also have failsafe instead of manual mode. I just change one end of the dual rate to get manual for calibration. Maybe a screenshot of the...

Woohoo! I knew you'd get it in the end.

That's the look I was going for! Thanks mate! Since I've started letting the zenmuse do all the panning my footage has become way smoother. I spend most of my time just keeping the skids out of the way whilst the zen does it's thing. I wish I had retracts sometimes!

Here's a collection of clips from around my local area, more of the same as I've been churning out this past couple of months: Cheers!

Hey mate! This is wrong, don't attempt to fly! I can only speak from my experience, naturally, but the throttle should be above at least 10% for failsafe to work. I have mine set to 50%. How do you activate failsafe? Through a mix? Usually people have the reverse experience, where flipping...

It sounds like it's in manual mode. What mode are you flying in?

I was surprised a marina looked so nice. I was initially worried I wouldn't be able to make it look good when I first arrived. Thanks Lec!

As above, just cut off the raised edge. You'll work out how to assign switches, it's a necessary skill to learn.

Probably because it's 3 years old?!

Something from last week. Just some clips from a documentary about canal restoration work: Password: riverboat

They don't make 10mW 5.8GHz transmitters. And you wouldn't get 800m if they did. I suspect you mean 2.4GHz which should get you a mile or so.

What transmitter are you using? Have you setup your mode switch?

Try running the tx from a higher voltage source. I use 12V. It works from 6-25V. No wonder it doesn't work with a 5V camera source. http://www.immersionrc.com/product-details.php?fpv_product=13

Get an ImmersionRC 600mW tx and a good rx with a patch antenna. I get 2Km with mine. 25mW should still get you 500m. I meet a lot of people who buy 5.8GHz video equipment assuming it'll work but not all 5.8GHz stuff is the same. You need matched components. The rx antenna is the most important...