Search results

I went out and flew my FC40 today. It is basically a Phantom v1.1.1 with a 5.8ghz Tx and the FC40 camera. You can look up the specs on DJI's website. I will be downloading both video and pictures soon. The basic set up is P1 and flies the same. I like the FC40 for what it was intended, a...

Javier send me the flight log and I will take a look at it and see if I can assist. If not, I know someone that can. Please included your set up including the firmware that you were using and a photo of the set up. That would help a lot.

Javier, There are a small percentage of failures. All products have that. In my experience, most crashes are caused by user error. Not all, but most. With your experience I would think that you would agree. If it is a DJI problem, have you contacted the dealer and if you got no...

Go and fly many platforms over many years and tell me that unexplained issues do not crop up in any of them. I have. These are complex systems in non-controlled environments. Interference both on the craft and external are ever-present. How do you point to just one thing, in this case DJI...

The number is listed on the DJI website as DJI NA. http://www.dji.com/company/contact/

Guys get real. Many manufactures have post intro deals. If you want to be first in line you will pay premium. I did with the P2Vision and purchased a second battery. It is what it is. Whining does not help. To say DJI and its dealers are at fault and you should compensate you is...

DHI's new North American Service and Support Center is up an running in LA. It is not fully staffed yet but it will be soon. Having service here in the US is huge for DJI. Having to send product back to China was not acceptable to most users. DJI has brought its best support staff to the US...

It was for the Phantom 2 with H3-2D. I find with the DJI Tx is is very smooth and i get 90 degrees of tilt.

Agreed. It is not clear in the manual.

Where did you get that??? I cannot see that anywhere close to reality.

That is solid yellow. The OP stated flashing yellow.

Normally the yellow flashing led means loss of RC signal/bind. You don't tell us about your setup. That would be helpful.

i agree. Wish I had an extra grand.

I agree.

I like the NanoTechs as well. I am flying with 4S 4000. I personally think that 5000 is heavy if you are using a gimbal, H3-2D in my case with GoPro H3, an iOSD, the mini and a vTx, an immersion 5.8gHz at 600 mw.

That is my expectations as well. I get 8-10 minutes on my F450 with virtually the same equipment. The Lipo and props are the difference.

Iris, You are so funny. I am not sure how the cir clip could just fall off along with a bearing. I have never had that happen.

Right now, I am not sure on the flight times. Mine has not arrived. As far as the 8FGS, the board/Rx is Futaba compatible. Sidney has posted the same over on RCG with a preproduction model. For the rest of us we have to wait.

I have a drill press and a step drill. Not an issue for me. :nevreness:

Blade, I have used the Graupner 10" and right now I am on the DJI 10x3.8's A good compromise in my opinion. That said, I am looking forward to the E300 with the 9" props. They have shown themselves to be more efficient on the Phantom Vision. We will see.