Search results

No one can fault this decision... I bet you laughed, then cried a bit when you first dd an autotune and it took 30 seconds.... MUAHAHAHA vs. MONTHS of tuning with Alexmos.

@GotHeliRC that would be great. I think quite a few people would benefit from it. I'd be happy to send you this unit if you can do a manuf. return. Let me know! SC

Well sorry guys, this will be on hold. AS my luck would have it, I have a BAD PMU. The eBay seller was nice enough to say "Send me the bad one, and I'll send a good one once we get the bad one." SO.. That's gonna be a few weeks I am thinking. My friend has 4 of them, and his all work, so i...

Hey guys, a new GUI has been uploaded: Software for ‪#‎gStabi‬ Released new version 3.7.2. In this Version we fixed some issue related to parameters reading and writing. The issue may affect on the performance of #gStabi, make it "crazy" Check it out at: https://www.gremsy.com/software-manuals

SO, I love me some carbon frames. But let me ask you, have I gone too far?!

Don't think so, but I did not use a bubble level. I guess I'm simply not that critical of minute little roll drifts. My reason is the people who pay me never complain about the footage I give them. If it''s moving an inch up and down, then yea I'd be concerned, but if it's a tiny, itsy bitsy...

AGAIN... have not seen anything about an OSD.

I can see that now, Uruguay... yea, that's not a day away from most suppliers!

There is no way a company can accommodate every gimbals proportions with one or two cables. And I also have a Zenmuse and the gimbals close dimensions are a challenge for almost all HDMI cables. That's actually a bad design on DJI's part. You can find a cable that fits your purpose better at...

Well not a great start. Looks like th 5V side of my PMU is dead. I pulled out a 5V reg I had and plugged it into the main FC and it powered up. BUT only after I removed all of my receiver inputs. I spoke to my friend and he had NONE of these issues... so I guess my luck continues! :(

Haven't seen anything yet about an OSD.

I used this one: R6208SB

I plugged in the Futaba T8Js through sBus and it worked GREAT. Super Smooth. I can say that the Futaba works perfectly.

I think you would have to run the Graupter as a "normal" RX, from what I can see the Gremsy only accepts sBus or standard PPM And you would need to modify the batt to supply power to a VTX, maybe make a piggyback harness. Personally I wouldn't do that, I'd let the batt power the unit alone and...

The X8 with the Avroto 3520's swinging 15" props should have no problem with a 11 - 15 lb payload on that frame. Frame/motors/batts/landinggear/FC ETC should be around 14 - 17lbs (depending on batt size) 3520 400Kv suggested use: Quad AUW 9lb to 12lb Hex AUW 12lb to 20lb Octo AUW 20lb to 28lb

The manual is kind of hard to find so my friend Tom sent it to me, and I'm going to post it here: (Attached PDF)

GUI is pretty familliar-ish looking...

It has begun...

$4 http://www.nghobbies.com/cart/index.php?main_page=product_info&products_id=174#.VYrGx1z0jds

That's the view from the new pad? If so.. NICE!!