Randy Slavin
New Member
New to this forum. Very thankful for it!
A couple of (probably easy) questions
I'm flying an S900/Zenmuse Z15 GH4/ Futaba 14SG and unfortunately I can't get my tilt to work. I've been able to map the tilt to the lever on the back of the TX but when I disconnect from the A2 Assistant It doesn't work. I've connected a servo cable from the A2(F2 port) to the GCU Tilt port but the gimbal just points up after it initializes.
Also I'd love to soften my yaw(and tilt whenever I get that to work) so I can get more smooth moves. How do I map softened curves to a switch so I can take off using the normal controls and then flip a switch to enable to the buttery smoothness once I'm ready for aerial magic?
Thanks in advance!
A couple of (probably easy) questions
I'm flying an S900/Zenmuse Z15 GH4/ Futaba 14SG and unfortunately I can't get my tilt to work. I've been able to map the tilt to the lever on the back of the TX but when I disconnect from the A2 Assistant It doesn't work. I've connected a servo cable from the A2(F2 port) to the GCU Tilt port but the gimbal just points up after it initializes.
Also I'd love to soften my yaw(and tilt whenever I get that to work) so I can get more smooth moves. How do I map softened curves to a switch so I can take off using the normal controls and then flip a switch to enable to the buttery smoothness once I'm ready for aerial magic?
Thanks in advance!