Naza-m v1 pmu v2 will not recognize tx yellow fashes

[brused]

problem= naza-m does not see Futaba tx+ 6 channel receiver flashes yellow

Help for solution Please
TX Futaba 6EX-2.4GHZ Receiver-RX-6
Calibrated as traditional, but TX not recognized, Nata-m flashes yellow and an odd red

flash when i try difereant settings on TX.

equipment= Multirotor F550 Naza-m v1, PMU v2 original led or VU ?
Full charge on TX, and receiver sees the tx 6 channel green led and digital
completed wiring for pmu set up very carefully, I see no errors.
channel u goes to channel 5, 2 position switch, yellow flashing, u goes to ch6 Same problem
I would be grateful for help.
Had GPS error and no receiver error.
Gps error possibly not resolved. Assistant software v2.20 firmware 4.x TX calibrated, gimbles.

Thank you in advance

 

[rilot]

Have you got your receiver type set to traditional in assistant?

 

[Tahoe Ed]

Check you endpoint adjustments. It appears that you are in failsafe or your system is not bound.

 

[brused]

Have you got your receiver type set to traditional in assistant?

Yes

 

[brused]

Check you endpoint adjustments. It appears that you are in failsafe or your system is not bound.

Actually you are correct, When it comes to these adjustments, I am in failsafe, Do i need to be in Gps ?
Can you explain this "not bound" meaning, to the software at that point ? or what Ed ?