Naza-M anf Futaba T14FG

[Quantumlight]

The problem is that I have is that I get the error message in the DJI Assistant.
View attachment 10701
I seen similar problems before but I tried and Tried and Tried. I spent over a day on just this issue.


I use Futaba T14SG
It is in situations Fasstest-14CH Single G
The receiver is R7008SB in position D (four red flashing then saved by pressing again)
These two are linked and the light turns green


The Reciver and Nazan is then linked by a cable through the sbus port # 8 to X2 on Nazan
VU is connected to the LED and X3 ports


I start the transmitter then connect the battery to the Quad.
The receiver turns green Nazan makes her sound sequence. VU flashes fast red (low power / error) the battery is fully charged
Connects VU with USB and DJI assistant then the error message I show above.


The assistant manager for TX cali so is reciver type of dbus.
I get nothing showing in the software from TX


So there lies my problem. What the hell do I do now?

 

[Tahoe Ed]

See if you can get it to work in traditional. The screen shot that you displayed is just the explanation of the various error codes. What does the lower right hand side of Assistant say?

 

[Quantumlight]

I get the FG-error[8] at the bottom and that list is what I see when I press it. The botom right sticks on failsafe.

I have followed this guys settings
http://youtu.be/ck3tu-4UVgg

 

[Quantumlight]

I found a solution today on the whole problem. What I did is to go over to 12ch on transmitter. Use traditional connection between Reciver and Naza and set Reciver to mode B.

I'm not happy with this and will go over to S-bus later when I can get some help on the issue.

 

[PeteDee]

I decided not to use S-BUS, I wanted to use some channels directly connected to remote switches so just used cables to plug it all together and it is working pefectly, I am using a 7 chan FASST Rx though.

Pete

 

[Boltzman]

Hi!

Have anybody found a solution to set up Naza with s-bus with 14SG TX and R7008SB?

Thanks

 

[Quantumlight]

With that receiver we are out of luck. Older recovers work but this one as I have is a new generation that is talking a new language that the naza don't understand so if you want to have telometry you need to get one of the older receivers that have S-bus(1) the new s-bus is not supported.

So we just have to wait to a new firmware comes out that speak the new language.

 

[ChrisViperM]

Check this: http://www.multirotorforums.com/showthread.php?9661-R7008SB-S-Bus-with-NAZA Post #9


Chris