LeeT
Wannabe AP Dude
When I initially set up the Naza, I had all trims and sub trims set to 0. The MR hovered and stayed in place just fine. Recently I added LED lights, landing gear, rerouted the wiring and swapped an older AR6100 RX to a newer one. I bound the new RX and calibrated all the TX throttle, rudder and cyclic and they all were in the green. As soon a it lifted off, it headed quickly headed forward and to the right (as if I was giving it forward elevator and right aileron). I have been able to get the MR to mostly hover in place by adjusting the sub trims on the elevator and aileron. When I hook it back up to the assistant the elevator and aileron sliders are no longer green.
My question is, what might i have changed to require adding sub trim? I can swap the RX back to the old one to see if that is the issue. Or is it normal to fine tune the Naza by using sub trim to keep the MR hovering relatively in the same place?
The Naza unit was not moved when rerouting the wiring, and the battery is in the original position.
Setting are 135/135/135/135 Atti is 95. Radio is a DX7.
Thanks,
Lee
My question is, what might i have changed to require adding sub trim? I can swap the RX back to the old one to see if that is the issue. Or is it normal to fine tune the Naza by using sub trim to keep the MR hovering relatively in the same place?
The Naza unit was not moved when rerouting the wiring, and the battery is in the original position.
Setting are 135/135/135/135 Atti is 95. Radio is a DX7.
Thanks,
Lee