1lifefilm
Member
Hi All
S1000 all done now and test flown but struggling a bit with connecting the IOSD line to the Immersion 600. I saw on an old thread the following advice but I need to know if this works or not before I try it.....don't want to burn the house down!
Any advice would be appreciated.
Simon
SEE BELOW
DJI side Immersion side
AV-Out (yellow) ---> Vid (yellow)
Av-GND (brown) ---> GND (black)
UART (2x orange) ---> not used, this is "channel selct", and this function is done via extra cable to transmitter
BATT+ (2x red) ---> 1x can be used to power the Immersion - BATT (this is the double Molex plug on the left side) - check Immersion manual for requiered Voltage
BATT- (2x black) ---> 1x can be used to power the Immersion - GND (this is the double Molex plug on the left side)
GND and 5V Out can be used to power your camera
S1000 all done now and test flown but struggling a bit with connecting the IOSD line to the Immersion 600. I saw on an old thread the following advice but I need to know if this works or not before I try it.....don't want to burn the house down!
Any advice would be appreciated.
Simon
SEE BELOW
DJI side Immersion side
AV-Out (yellow) ---> Vid (yellow)
Av-GND (brown) ---> GND (black)
UART (2x orange) ---> not used, this is "channel selct", and this function is done via extra cable to transmitter
BATT+ (2x red) ---> 1x can be used to power the Immersion - BATT (this is the double Molex plug on the left side) - check Immersion manual for requiered Voltage
BATT- (2x black) ---> 1x can be used to power the Immersion - GND (this is the double Molex plug on the left side)
GND and 5V Out can be used to power your camera