Search results

  1. Benjamin Kenobi

    wkm starting out of hand?

    I think it should be possible. Startup on level ground and allow to start properly then hand launch. Sounds like fun!!!
  2. Benjamin Kenobi

    S800 Motor temp

    Yeah, that's too hot. After 10 mins I can touch mine just fine. I tried some new lipos but the COG was off so the 2 rear motors were 3• hotter than the rest. Good to check temps each time.
  3. Benjamin Kenobi

    S800 Motor temp

    Erm, how did you determine the temp without a temp gun? Just your fingers?
  4. Benjamin Kenobi

    Show what you filmed - Post Your Video Here

    Hey, I had a chance to put my S800 through its paces: All footage straight from the GH2. No post stab. Sorry I'm not much of a video editor. Ben
  5. Benjamin Kenobi

    S800 Motor temp

    Are they all the same temperature?
  6. Benjamin Kenobi

    Wookong does not connect to computer

    Yeah, just try a few different USB ports. Only one of mine seems to work with DJI. Who knows why this is?! And you have to install the driver with the devices connected and powered on, at least I think you do.
  7. Benjamin Kenobi

    Twitchy wookong

    It could just be your gain settings. New frame, different gains. Are you comfortable adjusting gains on the assistant software? Like Chris said, you really got to reset and start from scratch when moving electronics between frames. Hopefully the people who set it up for you have dones so...
  8. Benjamin Kenobi

    Twitchy wookong

    Totally agree! Building from scratch means you can fix most things at the field and you'll instantly know what's up from any symptoms. I know building isn't for everyone but the cost of repairs when someone else is fixing can be quite high I imagine.
  9. Benjamin Kenobi

    Is your voltage reading correct???

    I have my VP set quite low. I think 3.4v per cell. It's only for emergencies. Haven't tested calibration though.
  10. Benjamin Kenobi

    S800 Motor temp

    Actually my motors did get warm this weekend with the high ambient temperature. Came down at 43C. How are you determining flight time? Are you putting back in 80% of the lipos listed mah when on the charger? Quite a few people have high voltage-cutoff settings which causes premature landings...
  11. Benjamin Kenobi

    Learn to walk before you run

    I totally agree. Get a 450 or 550. Teaches you basic setup and soldering and a nice kit to work on. Good luck!
  12. Benjamin Kenobi

    NAZA GPS & DX7 (Need help)

    I came from Helis and just stuck with what's familiar. It's about time I went to acro.
  13. Benjamin Kenobi

    GH2 reliable hack packs?

    I haven't had any probs except auto focus cuts out after a while (not that I use it). I reset all settings after installing a hack. Haven't had any playback issues. Uses about 5Gb for 10mins filming.
  14. Benjamin Kenobi

    Multirotor in the news and a few links

    The TED talk just makes our poor old GPS FC's look redundant. Very cool!
  15. Benjamin Kenobi

    graupner 9x5 or 10x5 on a F550

    I use 4S and 9" and love em. Motors run cool and lots of power! Have fun!
  16. Benjamin Kenobi

    GH2 reliable hack packs?

    I use Flowmotion V2.2 and love it. 50Mbps. You'll have to only use manual exposures and focus with this hack.
  17. Benjamin Kenobi

    NAZA GPS & DX7 (Need help)

    You can select non-CCPM too (i.e. 90• servos).
  18. Benjamin Kenobi

    S800 and zenmuse change between one and two operators

    Or you can pop another rx on the Zen for the cam op. No Zen control for the pilot though.
Top