Search results

make sure you do all the calibrations again. check fc straightness, make sure its not moving around also i cabletie mine down. check in the software you still have set-up correctly and your getting full range of sticks also

I have seen a edf drone before somewhere, no idea how to calculate the power needed

what transmitter/ reciever is it? have you run the dji software to check channels etc??

this could work if the power on the fan or air sucker has enough lift to overcome the weight of the board/battery you have

is the fc facing towards the centre of the craft? theres a little red arrow if it is off by a couple of degrees it could cause that wobbly effect.

Fc is facing correct position?

Ok so if you have checked the motor spin direction is all correct. did you put the props on correctly? I am thinking that the left spinning props are on the right spinning motors? that might cause it to do that behaviour i have done it myself. get someone to hold it in the air or strap it...

payload? price range helps? experience??

No one knows when the next mavic will be released, if they even release another one like or go in a different direction. You just have to wait and see!

you can also adjust it in the servo menu for your switch so it throws less or more

what camera???

upside down props?? or props are the wrong motors left spinning props are the right maybe?

where did u buy them from?

sounds like a gps problem not getting a lock, do all the calibrations again including compass etc and see if that fixes the problem

yes it would!!

you might want to try the dji forums for that https://sparkpilots.zone/forums/spark-discussions.10/ or https://forum.dji.com/forum.php?mod=forumdisplay&fid=115 no offense #dronevibes but it seems alot more active for dji stuff then this forum

hes our fleet its a missing another big x8

my first build was dji 450 easy enough to build and solder and get it flying theres a build forum somewhere too

play around with e-calc https://www.ecalc.ch/xcoptercalc.php?ecalc&lang=en

that connex prosight supports 27 different channels. As long as the connex hd is on a different channel you should not have any problems