Search results

I've tried a number of different monitor resolutions but the Assistant screen doesn't change at all.

The idle speed slider doesn't show up in Assistant because the window it's in doesn't scroll and is too small to display the whole screen. Any suggestions?

I decided to use them to ease the strain on the motor leads where they contact the frame.

I'm still where I was when I started. Plug battery in and LED settles in with 3 red 1 blue. ESCs are all chirping ceaselessly. I've connected with Assistant and the WK-M seems to be recording settings. I've checked every wire four times and can't find any polarity problems. Is it something...

That's what was wrong with the rudder connection.

Could I have damaged the bottom PC board when soldering? I had to rework the battery leads a few times. I've checked and rechecked polarity and wiring. I did find my Rudder connection was bad and replaced the wires. How can I be sure the WK-M has accepted the settings I put in the Assistant?

Config error 8. The LED is blinking red only. I'm trying to set up the tx. Now config error gone, transmitter sticks seem calibrated but still beeping and 3r 1b. If I have polarity problems how can I check with multimeter?

I see "version does not match" in Assistant. I'll check into that. I thought i should be installing version 5.08. I just got the WK-M, is it already loaded with a later version incompatible with 5.08 and 1.26? I got rid of version doesn't match, still no change in LED or beeping.

I had not sequenced the USB connection properly. I got into Assistant with MC Output Off but the menus still don't appear to function. ESCs still beeping constantly. The LED starts white steady, then goes through some colors, then 2 rd 1 blue, then cycles through continuous 3 red 1 blue. I did...

I plugged in the battery, 3 red 1 blue light and constant beeping (higher pitch than the vimeo) and radio seems properly bound. I run Assistant with hex V selected but it does not seem to be communicating with MC, no menu options are available. The Assistant MC Output On light is flashing and...

Polarity seems okay. I'm about to hook up the Assistant.

I just switched two wires, now I'm getting 3 red 1 blue flash. The one page graphics explaining the meaning of various flashes is not very clear. I have not hooked up the Assistant software becasue I was spooked by the noise and light, not knowing what to expect when I first connected the...

I have just connected up my electronics and I'm getting continuous beeps from the ESCs. I bound the radio but the beeping keeps up and the WK-M LCD is steady white. I'm inside, GPS connected. Can someone help?