Search results

Looking for opinions on the Braincube LED's and Controller. Are you pleased with their performance?

That does not look as robust as the GentLED but thanks for the link.

Thanks for the replies. Anyone using anything different?

Thank you.

I am looking for a good remote trigger for my nex5 that will operate both still and movie function - What do you recommend?

Is the VX5N brushless gimbal available in the UK? If not is it available in Europe? I would prefer not to buy from the USA as the import taxes are cripling.

Is anyone using the Photohigher Skyline gimbal stabilisation with success? Thinking of buying for my AV200 but can't seem to find positive feedback.

After full satellite lock has been achieved and there on no red flashes on the LED module I arm the esc’s, as the motors power up I get a blue fast blinking LED for about 1 to 2 seconds. Everyone else I know has a Green LED that blinks at this stage. Does anyone else’s LED flash blue at this...

My ESC's are optically isolated and SimonK, the red wire is not live so no need to remove it. It's better because the lead is not so flimsy with the red wire fitted.

And all that is needed is a few thousandths of an inch between each connector. Wouldn't you think the manufacturers would have sussed that by now!

Does anyone using Maytech ESC's have this problem with the servo plugs into the WK-M Main Controller? The plugs are slightly too wide and if you push them all the way into the MC the last plug at port 'F1' will not fit in as the plugs fan out. The only way I can get them all in is to only push...

What do you have your 'Current Limiting' setting at on your ESC's - Enabled or Disabled?

Is the video from the NEX-5R as good as or better than the 5N?

Where are you mounting your radians on the AV200?

I had been told that was a good thing to do. Thanks for your reply!

Can anyone show me footage from an AV200 fitted with Radians with no post stabilisation and preferably no cam stab. For those that have the AV200/Radian set up, how do you rate it?

I have heard that there have been an uncomfortably high occurrence of PMU failures? Has anyone had a failure of the DJI PMU? Does anyone recommend using a third party BEC?

Anything worthwhile between copper and brass in the conductivity stakes?

You don't need to solder to it! Brass is the next best thing and you can solder if required.

I liked the design but hadn't looked at the price.........Forget it! You are right, the multi rotor buyer is being ripped off in lots of areas. I shall make my own! Brass should be ok don't you think?