Search results

zippy 8000 3s lipo with 10 inch grupner props you get 12 minutes.

Tarot 2d gimbal draws a max of 1 amp. I lost 1:30 adding it. I los 1:00 adding the gopro, mini osd, and boscam 5.8 ghz vtx. Then the landing gear took 1 minute off as well so my total lost time was 3:30 seconds.

I've use nanotech 3000 and 6000 4s lipo With 3000 3:54 was normal 2 paired 6-8 minutes With 6000 5;58-9:00 was normal *depends on type of flying going out up ect* With 1040 15:36 Was 16km wind and aggressive flight into the wind with it ect. Still testing the big one but that's what I use...

I'm not sure of the weight but I have the following F550 Afromen ESC DJI motors(red ones) Landing gear (el cheapo plastic one 20 something) DJI mini osd Boscam 5.8 transmitter Tarot 2d Gimbal Lion power 4s Lipo 10400 Mah 25C Graupner 9 inch props (10 are better by 1 minute) GoPro Hero 3 black...

9.5 you have to ream the hole out it's not all drilled through. The 10 inch ones have an 8mm hole in the shaft so they fit right on no mods needed. I've flown both (they're the same) I use a lion power 4s lipo which is 10400 mah and I get 15 minutes in 16 km/h winds. I was happy with it I was...

I've done 2 packs before you just buy the wire or make a conector or wire and hook them up. Make sure they're both at the same level or bad things can happen. I found that the voltage sensor can be a little off if you pair the packs ie you can't blindly tust it. If 1 pack fails in flight you got...

Well you have a few choices... Sand the whole blade top and bottom works fine for plastic props. You can also sand the trailing edge the side that doesn't cut into the wind. If you sand the side that cuts into the wind you lose effecancy as it changes the lift abilty the most important part of...

here is a video of the 15 minute flight in 16 km/h winds. A storm was coming in so it was very gusty and a constant wind.

I like the hoverbot HB8 frame that sucker is rock solid I've seen it take massive noise dives into the ground trees ect still standing. Other frames they went crunch. The difference is it's all carbonfiber or g10. http://hoverbotfpv.com/ Build it like a F450 and you got a decent fpv flyer...

you could always just go with a tarot 2d gimbal it's less money works well and has everything you need just buy the one with the mount you want.

The naza has a auto shut off feature once it hits that limit it turns off. I disabled IMC Imediate cut out because it does that I set mine so it will come down but won't turn off till it crashs into something (props stop spinning) or I cut it. I did that to prevent it from falling once you lose...

Ok I did some testing for my setup it's the following it's like yours I have grabner 9.5 props. All are 4s Lipos I run a 6000 mah battrey weight around 620g I get 11 minutes of hovering 5:30 really fast flight If I run a 10400 mah Lion Battrey which is 1000g I get 16 minutes in 16 km/h wind...

Ok I just got back from flying in 16 Km/H wind I got 16 minutes of flight and that was moving around and doing things up down foward back ect not just hovering. I hovered for a while to see what sort of drop in voltage I would get it sure goes down slow. It's impressive for the weight I run 2...

I would look the motors over well pull on them make sure they don't have any right and left play up and down you can break a locking washer and not know it till the prop flys off. Also look at the props top and bottom tip to the hub hidden cracks can supprise you. Make sure your conections are...

Did you do a calibration in the naza software? You have to calibrate the remote so it can find the min and max of it

O yah... 1 wire got nicked from the folding arms http://youtu.be/Eo8CfIyCF8U

I like the Hoverbot HB8 frame. You can set it up as an H quad or an X because you can adjust the arms it also folds up which is nice. The size of the motors are your choice so it's built to what you want. You can use 8, 10, 11, or even 12 inch props if you want. That's what I'm going to buy for...

not all ipads and ipods work with the software. I think I had to turn mine on in the software I don't remember if I had to or not but I think I did. Mines green and hooks to ipod 5 or higher and for ipad I think it's 3 or higher.

The home location if locked might just land if the battery is low. Which is why you should always do the far away stuff right away. If it's to low home location means nothing.

If you take off in altitude or manual mode the home location isn't set. If you fly in altitude mode it forgets it's homelocation and sets it to the last one if you goto gps 100m away I thinks that's the home location it will land if it only has x amount of power. Its a finiky system but if you...