Search results

What is the weight? Wait just looked it up...~3lbs correct? Our Scripta will fly that. The Erista would as well with room to spare. Safe....I would also recommend 8 rotors over 1

AL Gain = Main Gain If you want to make them the same value on the TX thats fine. If you want to make them the same value on Setup thats fine too. They should be only a few percent different and this is not going to matter that much. The second Post on this Thread: "same gain on TX. The...

Can't help you with the specifics of our RTF aerial systems. However, I will tell you that in general lower pitch is better.

You could heat shrink it being careful not to melt any components on the board. You will also want to leave the LED visible (maybe clear heat shrink). You need to use the voltage required by your servos. This is in the manual.

Read the text on the picture you posted once again. It can be mounted near a STATIONARY servo just not one that will be movig back and forth. There is no box...because we typically dont use them on our controllers. Same as MK

Ok....internal pots are probably fine. Try adjusting your advance. Also make sure that your scale value is set correctly.

Yup it's most likely your pots.

You have a Yaw imbalance. This is usually caused by motor misalignment. Fly for a minute or two and land. Disarm and feel the motors. If CW are warmer than CCW or visa versa then motors are not straight up and down. It can also happen due to ESCs not being calibrated or a motor spinning in...

You're gonna need a bigger octo! :nevreness:

She's gonna be top heavy. It will still fly but I would add some payload on the gimbal.

It IS a firmware change. All versions of the HoverflyGIMBAL have exactly the same sensor capabilities. It is exactly the same design I just added signal buffers on the servo outputs. This addition will never matter to you unless you are using cinestar servos. If you already have a...

Go on the support ticket system and request an RMA. I will try it here and if it is faulty we will send you a new one.

The new version of the HoverflyGIMBAL is available now. The only difference between the first version and the second version is the addition of signal buffers so that it works directly with cinestar gimbal servos. Regardless it is available. If the store says backorder, we are getting...

Ok thats it....I am having the gain readout on the setup client removed! This has confused everyone since we added it. BTW the manual doesnt say anything anywhere (that I am aware of) to adjust gains in the setup client. Can someone point me to the "un clear part"

And so it shall. Dan will have it out in the next few days. Might want to wait on selling yours Twister773!

Guys gyro only will be out in a few days. We should have released this first but everyone was asking for Magnetic hold. The Skyline nor the Radian will be able to do Magnetic hold BTW.

same gain on TX. The gain in the setup client will be different for different transmitters. What matters is that you go fly on manual gyro only mode. Adjust your gain as it shows in the manual. Once you find a value on the TX that you are comfortable with then set the AL gain to the same...

You will probably need to adjust the Set Ranges on the Receiver Configuration. You can set a maximum deflection rate. Dan is about to release a new version of FW with enhanced Pan stabilization. I will let him comment on it.

Yes this could be a possible problem because if the contrast is too low sometimes the monitoring device wont be able to sync

Please try these and report back.