Search results

does that tfr have rssi?

I've never tried that video combo, those chineese systems like that are noisy, definately stay away from higher power 5-8ghz-uno-a-v-receiver.html ImmersionRC 5.8GHz 600mw Audio / Video Transmitter 5.8GHz Mushroom Antenna Set what is that, $20 more? on the aircraft side, using immersion...

heavy heavy hitters.... can't wait to see where this goes...

michael, i'm at 1.2 on all but altitude is 1.0, gain knob is around 20% i like the immersion stuff too but i tend to support getfpv so i'm doing the luminier monitors,,, they got some nice cameras too but you mentioned having that

28lb hex with superX in a wind tunnel....

we did a bunch of dji arm testing and the red or white arms shake alot more than the black,,, it makes jello issues, makes rotational deflection worse.... it'd get black arms and dress em with lights for color if you need orientation

the not stopping is most likely the motor settings "cut off type" intelligent does like he said it does now

I've watched alot of those guys i hung out with then here now with phantoms,,,

Our engineer got a pile of data and film to analyze. in the end it was a media day with benefits

our final edit...

I've never opened one up and only flew them as actors a couple times..... i bet you know more about these than me.... but as a long time naza user your assumption sounds right.... i just built 4, they all did that till i got the rc rx setting correct.... it seemed like the gps calibration thing...

aligns been messing around half way with this stuff forever,,,, years my guess is they'll never get the market share they had in SRH... there weakspot has always been electronics,,, never did have a decent flybarless controller after years of trying,,, everybody would buy there flybarless kit...

ppm is a single wire connection like graupner or any uhf system like ezuhf, dragonlink, etc. d.bus is a single wire connection for sbus futaba receiver, traditional is like shown above with all the wires going to a receiver pwm channel. I thought phantoms were like a one wire dji setup,,,, using...

the native composite only does playback, most use live feed to frame, etc. I bought the $7 cable, tried and realised what it was.

depends on the system but in a worse case as well...... if i remember right the video channels on the osd pro don't have a buss type ground to the vid channels and they rely on passing through a ground. the bec and the power/ground is a must always

it might want a ground with the yellow wire. depends how it's all setup, the rest yea, red and black from bec or seperate packs

have fun

if your all in that last line sums it up.... lidar/ads-b too on the hobby fpv side minis are all the rage..... saw a dope little flare stack inspection rig the other day, super affordable and small..... still top seceret

hit your safe switch and see how it starts off, it's easier to position the rig up where it'll try climbing to and not far from it latteraly, makes the controller give the easiest input to the rig to pull it off

the mention of heat heads down the esc incompatibility road.... put on one prop, take it outside and hold it down well, rev the throttle, see if it is locking up with fast input... for futaba you have to go to the "failsafe menu" and set the channel controlling safe mode to be set.