Search results

Yes, you will have reduced range particularly in turns

There are some settings which the Nex should be set to according to the manual, 1080I I think, check the manual. I did have a look to see if your VTX and VRX support the same channels and they do so it should be ok, On your monitor you need to have SW4P and SW5pP both set to on to be in...

No it can be in any mode

I would say it it more likely that it is your cables to the charger than a bad battery. Check your balance charge leads, possible one of these is loose either or your battery or from the charger to your battery, If you have a small Lipo alarm, connect this to your battery to check the...

How many Amps were you charging at? even at 9 amps it should only take an hour but if the cells were uneven the balance charge can take a long time to finish off by topping off and discharging each cell to balance. The CAPA message is probably a max setting in your charger to only charge to a...

I am not aware of any new IUM for the A2, I thought there has only ever been a IMU V2 for the WKM

HI Gary, Also in Chester, give me a shout if you need anything. Best of Luck,

Hi Jumpy, I will PM you wen they get closer to being ready, After this first run I will see who much interests there is producing a bigger batch.

Hi Flitelab, A couple of pictures for you, The SBUS+ is under the FrySky Receiver, The green light is signalling the fail safe status. There is one wire from the receiver to the SBUS +, One wire from the SBUS + to the Zenmuse controller. This is operating on a single TX. On the TX it is...

The current ground station app does work with the A2 2.2, just tried and everything seams fine,

Yes thats the DJI Assistant app from the 27th March, I meant the Ground Station app

Just checked and there is no new app for the iPad, the current versions 1.4.58 from march, no new updates avaliable

From the pictures I still cannot see where the video input to the OSD is coming from ? There should be a headphone like connector coming from the ZEN to the OSD.

Just a little black box at the moment, I have it housing a second receiver, but this will be removed from the production units. I will post some picture and a screen shot or two later.

Hi Guy's I have a working prototype of a decoder that I have made and which will address some of the issues you have here, The decoder is accepts a S.BUS input and then maps the channels for output correctly to the zen Inputs S.Bus Outputs Sbus - Un Modified Signal ( Like a Y Cable) Sbus1...

try swapping your motors around to the bad esc, if the old motor works on a new esc and the new motor does not work with the old ESC then it is most likely you esc is damaged. You can plus the ESC directly into your receiver if you wan to avoid going through the FC. If it is the ESC then you...

Sorry, I do not have telemetry on my transmitter, One way to check would be to use a multimeter to see which one is giving the right values. For the difference between the S800 and S1000 you need to find your own voltage end points that give you 20% remaining, It sounds like for the S1000...

More confused than ever now on this product, Let me see if I have this correct - Transmiter uses trainer port to connect to Lightbridge Ground system - Light bridge sends signal to Lightbridge air system - Air System sends signal to A2, bypassing built in A2 receiver - Gimbal control needs to...

Have a look at Hobby King, they have a UK warehouse and ship quite fast. Not sure if they have Thunderpower, I have got some nano tech from them in the past.

So basically they tweaked it!!! It would be good to know how this effects it, so if it does stuff up in a strange way it can be explained. Enjoy you hydrated plant extracts, I will have for a fermented plant extract