Search results

Ok first you need to power it with 7V from a BEC but yes you will loose battery sensing. We recommend that you stay below 17V because the regulators on the PRO will get warm beyond this. However it can handle 6s (25.2V fully charged) but you will need to add a small heat sink on top of the...

Merry Christmas from the team at Hoverfly

Its gain or the potentiometers. Might be the acceleration rate gain also.

DO NOT re-center your trims after reconnecting the battery.

There is a major revision of the SPORT firmware coming out soon. It will fly as good as the PRO on manual mode with the AP firmware.

its probably not going to affect your system. Its part of the power filtering. Try it and fly low

So the short answer is No. Let me explain. The SPORT came out well before the Naza and was just meant for sport flying around and for this you only need a gyro. At this point, it is not a popular product since for the same price you can buy a Naza. I still believe it flys better than a naza...

Not all setups require the filter. I never used them on our setups with the green boards. I did have one power reset towards the end of our internal use of the green boards but thats it.

I'll ask Dan, the lead engineer on this, to comment. I am fairly confident that it has been resolved. GGoodman was having some major issues with his gimbal but as I understand he is now very happy with the performance. He sent us one of his gimbals to test with and Dan demonstrated it to me...

I find it odd that you have this opinion yet I replied to your thread and also sent you a PM. As far as EMI/RFI shielding this is not a problem we have found in the HFG. The circuit is almost pure digital. In addition, the EMI/RFI coating on many of the plastic enclosures contains nickel...

PM sent to SleepyC

But you could just mount the external magnetometer under the dome 2.5 inches above the board and achieve the same result I believe.

Just some ideas of what to try. Receivers emit frequencies and noise too.

If possible I would move the video transmitter to the other side. Also make sure all SMA connectors to antennas are tight. The external magetometer wires going under the video transmitter is probably not a good idea. Just a few suggestions.

At what percentage throttle does the craft hover? 25%?, 50%?

Give the SPORT a shot. I just asked Ben to send you one :)

Connect the PRO to the setup client. Turn transmitter on. Power craft and make sure all of the channels and switches are exhibiting the correct motion.

When Ben mentioned that you had good results with a plastic box I didn't realize that it had a metalized coating on the inside. I would like to arrange to get one of your boxes for testing. Can you PM me your contact info. Also, how did you ground the metalized coating to the common of the...

That has never happened to me.....well maybe once or twice...:nevreness:

Do you mean like Evidence? Its two guys for the whole country....I wouldn't worry about them showing up.