Thanks that makes much more sense. So on the topic of esc, what range of Motors are ok to use with 30A esc (came with my 550)
Sent from my iPhone using Tapatalk
Ok so a 6000mah 3s 25c and a 5000mah 3s 25-30c are ok with eachother? Could you point me to a good pack (5000mah at least) inneed some new ones and idk what to get now
Sent from my iPhone using Tapatalk
Thanks, so I am
Getting 1047 props and the 2212/920kv motors. May get the E310 motors tho from DJI. Thoughts? I'm running now 5000mah 3s 25-30c batteries. Can I run dual and get more flight time? What's the benefit of dual batteries?
Sent from my iPhone using Tapatalk
so i have 2212/920kv motors, for the dji f550 so what battery should i get for longest flight. its a film drone and peak power wont be used as in flying fast or crazy maneuvers, mainly hovering or slow movement. Please help thanks
Sent from my iPhone using Tapatalk
so i have 2212/920kv motors (the black ones), for the dji f550 (aluminum arms so its a little lighter) so what battery should i get for longest flight. what is a trustworthy lipo manu? its a film drone and peak power wont be used as in flying fast or crazy maneuvers, mainly hovering or slow...
I have a fat shark 5.8 RX and a spectrum dx8. My screen is Aneagle[emoji768] 5.8G 40CH 7 Inch HD LCD Receiver FPV Monitor System Dual Antenna Built-in DVR with HDMI AV Input Li-po 2800mA/h Battery Wireless Diversity Receiver. It's just your generic screen etc will this pair with my GoPro...
$500 obo, (prefer local buyers) PORTLAND/ VANCOUVER AREA (Washington and Oregon only)
Everything you need to get into this kinda stuff. Controller (wiped clean and ready for your use) as well as two(yes 2) receivers. Just program the RX and tx and your ready to fly. Obviously program your...
So if I ziptie a gimbal from the top piece to the bottom of the frame, will that effect it? I have the proper isolation balls
Sent from my iPhone using Tapatalk
I have a couple questions, hoping to get 550 and 450 owners together for discussion old and new.
My question is can I just replace my RX and TX from Futaba to spectrum and be good to go once linked up? Any trimming or calibrations needed? My futaba either went out or I messed something up so...