Hi,
There is problem with AV200 and WKM. I have X4-setup and therefore I connected gimbal servos to R and T connectors. I enabled gimbal on assistant software, but servos does not react and assistant shows X2 and X3 are 1000. However, when I disconnect servos WKM works normally. Any idea what causes this?
There is problem with AV200 and WKM. I have X4-setup and therefore I connected gimbal servos to R and T connectors. I enabled gimbal on assistant software, but servos does not react and assistant shows X2 and X3 are 1000. However, when I disconnect servos WKM works normally. Any idea what causes this?