try this, when you get done programing an esc and while it's powered up with a motor on does the throttle stick turn on the motor? like not through naza, just through the throttle channel of the rx. is it beeping like normal when you boot it up?
Hi Kloner
Done that completely, all motors spun up when attached to the Rx throttle channel itself (red wire connected).
Removed red wire, plugged all into the NAZA controller, set it all up on the Assistant - latest version.
Motors now initialize on CRC, BUT even with totally full 2200 11.1v lipo, it cannot get enough power to lift off the ground at all.
This was the progblem I had originally that made me change frames. I have 10 x 4.5 props on board, and the lipo indicator shows that it goes down to no LEDs at full throttle, and returns to full capacity when throttled down.
So progress at least, many thanks for that, but I still have no lift on it at all.