yeehaanow
Member
It flies great. Lot's of fun. Gps all setup and RTH works great.
VERY powerful system. Hovers at about 35% throttle and flies for 15 min on 4s 8000 mah.
Maytech 30A 400 hz ESC's
Naza w/ GPS
Avroto M2814-11S Short Shaft 770KV motors w/ upgraded ceramic hybrid boca bearings.
This frame is new and I was testing the motors, so that's why the wires are bundled up and not cut to length yet.
The whole system was on another frame that suffered a flip and some spills along the way. Flip was caused by loss of a cell in my battery, and the low voltage cutoff on the esc not being set to nimh! They are set right now. Some of the prop shafts were cut shorter due to being bent. One esc was opened to check it, and re-shinkwrapped.
It runs quite smooth but could use some TLC in the motor balancing dept. They all have upgraded boca bearings, and included are 2 more sets. ($12 each bearing!)
The bottom plate has holes drilled that fit the cinestar 6 gimbal plate.
Ready to put your Rx on, setup and fly. 10x 4.7 apc props.
Would be good for a small gimbal AP/AV setup, especially with motor extensions.
I can make a video of it flying if we get some decent weather soon.
This setup new cost over $1000 with the boca bearings.
Priced for quick sale at $690 including shipping and PP fee.
SOLD AS-IS. PLease ask questions.
Comes with various little parts and screws for the motors and frame, naza usb cable and maytech manual.
View attachment 6724View attachment 6725View attachment 6726View attachment 6727View attachment 6728
VERY powerful system. Hovers at about 35% throttle and flies for 15 min on 4s 8000 mah.
Maytech 30A 400 hz ESC's
Naza w/ GPS
Avroto M2814-11S Short Shaft 770KV motors w/ upgraded ceramic hybrid boca bearings.
This frame is new and I was testing the motors, so that's why the wires are bundled up and not cut to length yet.
The whole system was on another frame that suffered a flip and some spills along the way. Flip was caused by loss of a cell in my battery, and the low voltage cutoff on the esc not being set to nimh! They are set right now. Some of the prop shafts were cut shorter due to being bent. One esc was opened to check it, and re-shinkwrapped.
It runs quite smooth but could use some TLC in the motor balancing dept. They all have upgraded boca bearings, and included are 2 more sets. ($12 each bearing!)
The bottom plate has holes drilled that fit the cinestar 6 gimbal plate.
Ready to put your Rx on, setup and fly. 10x 4.7 apc props.
Would be good for a small gimbal AP/AV setup, especially with motor extensions.
I can make a video of it flying if we get some decent weather soon.
This setup new cost over $1000 with the boca bearings.
Priced for quick sale at $690 including shipping and PP fee.
SOLD AS-IS. PLease ask questions.
Comes with various little parts and screws for the motors and frame, naza usb cable and maytech manual.
View attachment 6724View attachment 6725View attachment 6726View attachment 6727View attachment 6728
