I had the opportunity of purchasing Kloner's DJI Naza FPV quadcopter this past fall. He is an awesome guy as many of you know on these forums.
To my misfortune, I had my appendix take a turn for the worst late 2012 and had to have it removed on no insurance (college student) so I had a 20k bill to pay. I still have to pay about $800 a month on top of my living costs so I need to sell this to make payments.
I don't know as much about tech spec's of RC stuff as you guys so bare with me. Immediately below is the spec quote for the 450 itself from Kloner. I will list the many other items that are included also.
"kloners f450 fpv frame with dji 30 amp esc's, suppo 2814 motors, graupner prop adapters, graupner 9x5 prop, naza, jello free gopro mount fully test flown and truly ready to fly with a set of the fat shark predator goggles customized"
5.8 Ghz RX,TX FPV Video System
2 GoPro HD's (Motorsport Editions, never used the kits so they are brand new) (one has a scratched lens from falling off but can be fixed for under $80) 1 brand new, 1 scratched
1 - San Disk Ultra 16GB 30MB/s high end SD card
1 - Layer Lens GoPro lens protector (Light weight protection)
6 - Turnigy 3000mAh 4S 40C Lipo Pack Batteries (2 of them got ran a little low but still work fine, I just use them for test flights etc.. to be safe)
8 - Brand new Graupner E Props 9x5
Tons of extra used Graupner props (Donated to me)
1 - Futaba T8J (Everything Setup RTF)
1 - Fat Shark Custom Goggles (More comfortable than stock)
1 - Eagle Tree GPS/OSD System
1 - Jello Free GoPro Mount
1 - Clover Antenna
1 - Thunder Dual Power AC680 charger with all charging cords required
1 - Spare Brand New DJI 450 Arm
Many other upgrades such as radio battery etc..
Also - Anything else I missed which is in the picture is included.
Kloner (http://www.multirotorforums.com/member.php?1417-kloner) informed me that it is ok for you to ask him detailed questions about the setup since I only know the basics of what the build is.
This setup is extremely nice and has very clear video feed (5.8Ghz). From what i'm told, with the current video setup it will work 2-10 miles depending on interference. The radio currently is stock 2.4 but can still work up to 1/2-1 mile and the whole system would be extremely long rang if you decide to add a UHF system at some point (5-10miles).
I only flew the quad 3-4 times before I got sick then it was winter. - Below is a video of me flying about 2,500 feet up a mountain and followed by Kloner flying a mile on the quad.
-Me-
http://www.youtube.com/watch?v=DXQ4BymsiN4
-Kloner's Mile-
http://www.youtube.com/watch?v=dIrQpoE-ghM
Here are some Images:
View attachment 10562View attachment 10563View attachment 10564View attachment 10565View attachment 10566View attachment 10567View attachment 10568View attachment 10569View attachment 10570View attachment 10571View attachment 10572View attachment 10573View attachment 10574
I bought the system lightly Used for $1,500 from Kloner then another $400 in other required items such as Battery's, Props, SD card, Light weight GoPro case etc.. so I am in nearly $2,000 not including the GoPro which would put it at $2,300.
I am looking for $1,399 PayPal Gifted + $25 shipping.
This is the complete package for someone that wants an awesome proven and stable FPV Multicopter system. It flys over 50MPH from what i've heard, I did not fly this fast however. Everything is RTF Plug n Play ready. Completely setup and tuned. When I was trying to get into this and build one of these, everything priced out was around $3,000 new and Kloner completely suprised me in how generous with his time to help me and to give me a steal of a deal on his Quad. Truly the best person I have ever worked with on something. Thank's again Kloner for all the hours of help you gave me. I hate to have to sell this when I just got into it, but I have to sell it to pay medical bills.
To my misfortune, I had my appendix take a turn for the worst late 2012 and had to have it removed on no insurance (college student) so I had a 20k bill to pay. I still have to pay about $800 a month on top of my living costs so I need to sell this to make payments.
I don't know as much about tech spec's of RC stuff as you guys so bare with me. Immediately below is the spec quote for the 450 itself from Kloner. I will list the many other items that are included also.
"kloners f450 fpv frame with dji 30 amp esc's, suppo 2814 motors, graupner prop adapters, graupner 9x5 prop, naza, jello free gopro mount fully test flown and truly ready to fly with a set of the fat shark predator goggles customized"
5.8 Ghz RX,TX FPV Video System
2 GoPro HD's (Motorsport Editions, never used the kits so they are brand new) (one has a scratched lens from falling off but can be fixed for under $80) 1 brand new, 1 scratched
1 - San Disk Ultra 16GB 30MB/s high end SD card
1 - Layer Lens GoPro lens protector (Light weight protection)
6 - Turnigy 3000mAh 4S 40C Lipo Pack Batteries (2 of them got ran a little low but still work fine, I just use them for test flights etc.. to be safe)
8 - Brand new Graupner E Props 9x5
Tons of extra used Graupner props (Donated to me)
1 - Futaba T8J (Everything Setup RTF)
1 - Fat Shark Custom Goggles (More comfortable than stock)
1 - Eagle Tree GPS/OSD System
1 - Jello Free GoPro Mount
1 - Clover Antenna
1 - Thunder Dual Power AC680 charger with all charging cords required
1 - Spare Brand New DJI 450 Arm
Many other upgrades such as radio battery etc..
Also - Anything else I missed which is in the picture is included.
Kloner (http://www.multirotorforums.com/member.php?1417-kloner) informed me that it is ok for you to ask him detailed questions about the setup since I only know the basics of what the build is.
This setup is extremely nice and has very clear video feed (5.8Ghz). From what i'm told, with the current video setup it will work 2-10 miles depending on interference. The radio currently is stock 2.4 but can still work up to 1/2-1 mile and the whole system would be extremely long rang if you decide to add a UHF system at some point (5-10miles).
I only flew the quad 3-4 times before I got sick then it was winter. - Below is a video of me flying about 2,500 feet up a mountain and followed by Kloner flying a mile on the quad.
-Me-
http://www.youtube.com/watch?v=DXQ4BymsiN4
-Kloner's Mile-
http://www.youtube.com/watch?v=dIrQpoE-ghM
Here are some Images:
View attachment 10562View attachment 10563View attachment 10564View attachment 10565View attachment 10566View attachment 10567View attachment 10568View attachment 10569View attachment 10570View attachment 10571View attachment 10572View attachment 10573View attachment 10574
I bought the system lightly Used for $1,500 from Kloner then another $400 in other required items such as Battery's, Props, SD card, Light weight GoPro case etc.. so I am in nearly $2,000 not including the GoPro which would put it at $2,300.
I am looking for $1,399 PayPal Gifted + $25 shipping.
This is the complete package for someone that wants an awesome proven and stable FPV Multicopter system. It flys over 50MPH from what i've heard, I did not fly this fast however. Everything is RTF Plug n Play ready. Completely setup and tuned. When I was trying to get into this and build one of these, everything priced out was around $3,000 new and Kloner completely suprised me in how generous with his time to help me and to give me a steal of a deal on his Quad. Truly the best person I have ever worked with on something. Thank's again Kloner for all the hours of help you gave me. I hate to have to sell this when I just got into it, but I have to sell it to pay medical bills.
Attachments
Last edited by a moderator:
