JLO
Member
Hello to all
This may be an old question but here it is again its my understanding that a piece foam has to be attached to the pressure sensor of the MK FC I saw a picture somewhere, is this right? what is it for?
Quote from http://www.mkmanual.com/section-7--...ronics/flight-control-sensors-and-calibration
"Note: It is important to be aware that this is a standard "off the shelf" part and needs to be retrofitted for the MK by covering the small pressure port with open cell foam held in place by shrink wrap."
This may be an old question but here it is again its my understanding that a piece foam has to be attached to the pressure sensor of the MK FC I saw a picture somewhere, is this right? what is it for?
Quote from http://www.mkmanual.com/section-7--...ronics/flight-control-sensors-and-calibration
"Note: It is important to be aware that this is a standard "off the shelf" part and needs to be retrofitted for the MK by covering the small pressure port with open cell foam held in place by shrink wrap."