Hoverfly New firm 4.8 PRO, problems with the roll of the gimbal

[fort1952]

Hello,

With the new firmware 4.8 the roll of the gimbal does not work well, I tried to adjust it and ignores the parameters. Would anyone happen?

I've tried other servos and similarly

Servo movements are erratic and barely moves the center, only recognizes the roll center movement parameter.

Regards.

 

[Photronix]

We will take a look but there weren't any changes to this part of the code. Actually I we set up a gimbal (controlled by a HoverflyPro) Friday and it worked fine. I think you will need to check your setup.

 

[kloner]

potis are notoriously cheaply made. wiggle the wires going into it, if the gimbal jumps around that's your problem. sometimes flicking them will show a problem too, not hard, just a tap with the fingernail. it is what controls center

 

[Bartman]

also be absolutely sure that you're waiting for the LED to flash purple before clicking the COnnect button. then wait for it to connect and flash purple again before touching any of the adjustments. if you click connect before it flashes purple it will act as if it is connected but your parameter changes will be for nothing as they won't be saved.

bart

 

[fort1952]

Thanks for your responses, I checked everything again.
I invested servos connection in HFP (on the tilt connection I put the servo roll) and the tilt connection the servos all work perfectly. the connecting the roll does not work as it should work.
Roll movements are very short on the center and can not adjust the angle of roll

 

[Photo Elevate]

I have just checked my gimbol with the latest firmware and it is working fine.

Have you opened up the roll travel sliders fully as per set up client.

Here is the guide that shows you how to set it up.

https://hoverflytech.zendesk.com/entries/20955538-Camera-Mount-Compensation

Hope this helps.