Tomstoy2
Member
Here's the deal.
Got myself an ezosd with 100A current sensor.
When I first powered up I got the display but no voltage display. I am running a Boscam fpv system which has different pin out than FatShark. I missed the power swap on one of the cables and ended up shorting out the sensor.
While waiting for a replacement I uploaded the sensor calibration firmware and tried to see if the problem with the sensor was in there. It wouldn't let me do anything with the bad sensor so uploaded the TBS firmware.
The error screen would not go away, " error; current sensor diagnostics 2.1.
I could not get back to the main display screen.
Today, I received the new sensor and installed it. I hooked back up to the pcu.
The error has now disappeared but I can not get out of the diagnostics screen.
Went back in and uploaded the loader fw 1.3(?) along with the TBS fw 1.2.
I still can not get back to the normal display.
What am I doing wrong?
Got myself an ezosd with 100A current sensor.
When I first powered up I got the display but no voltage display. I am running a Boscam fpv system which has different pin out than FatShark. I missed the power swap on one of the cables and ended up shorting out the sensor.
While waiting for a replacement I uploaded the sensor calibration firmware and tried to see if the problem with the sensor was in there. It wouldn't let me do anything with the bad sensor so uploaded the TBS firmware.
The error screen would not go away, " error; current sensor diagnostics 2.1.
I could not get back to the main display screen.
Today, I received the new sensor and installed it. I hooked back up to the pcu.
The error has now disappeared but I can not get out of the diagnostics screen.
Went back in and uploaded the loader fw 1.3(?) along with the TBS fw 1.2.
I still can not get back to the normal display.
What am I doing wrong?