Naza v2 gps combo led

[Prehn]

Hello.

Got a f450 together and trying to figur out the led blink.

i have not calibratet the compas yet, and i Think it it solid red and orange? Both always on.
I have printed the blink code but not sure how to read it.

And cant get it to start up compas calibration. Is it not flicking between atti and gps mode on the transmitter.

Hope you understand what im asking for.

 

[Tahoe Ed]

You need to calibrate your compass in an open field away from all interference. The switch goes from Manual/ATTI to GPS and back on a three position switch. That is one cycle. Do that 6-8 times and pause, you should get a solid LED then rotate horizontally, the LED will change color, point the nose down and rotate until the LED flashes and you are done. If not try again. Have you calibrated you Tx in Assistant? You need to do that and make sure that your mode sliders are all highlighted in blue. Start with the middle switch position and use sub trim then use the end point adjustment in your Tx to get the other switch positions calibrated.

 

[Prehn]

Thanks. Got the dji transmitter and it is calibrated both in its own program, and in the naza program.

Perhaps it already made a solid red led, but it looked like two colors where on at the same time, maybe i saw wrong, as it is really bright.

 

[Tahoe Ed]

Sometimes it is hard to see the LED's. Especially since they are under the quad now.

 

[Prehn]

Have a braked that flips it 45 degres. I Can see it when it stands on the Ground.

But is the led a multi color led, or are there a led to each color? I Think i saw two colors at once, and it confused me. Will try again tomorrow if i Got the time.


Sent from my iPad using Tapatalk HD