I have a brand new Naza-M v2 installed on a brand new hexacopter.
My problem is that it will not arm and start the motors.
This is the case:
When running the Assistant software all setting is ok. All sticks are going the right way. I can test all motors, and they are spinning the correct way while testing. Both basic and advanced calibration is done. No error messages is displayed.
When I power on the copter, and my Futaba radio (with sticks positioned in GPS mode) the Naza will at last blink rapidly green to times (which is ok). When this is done i perform a compass calibration, which can be done with no problems. Then I try to arm the copter (sticks bottom right/left) but nothing is happening.
I also have another hexacopter which is running perfect with another Naza-M v2, with the same settings. This copter is configured with the same computer/assistant software.
Any ideas on whats wrong?
My problem is that it will not arm and start the motors.
This is the case:
When running the Assistant software all setting is ok. All sticks are going the right way. I can test all motors, and they are spinning the correct way while testing. Both basic and advanced calibration is done. No error messages is displayed.
When I power on the copter, and my Futaba radio (with sticks positioned in GPS mode) the Naza will at last blink rapidly green to times (which is ok). When this is done i perform a compass calibration, which can be done with no problems. Then I try to arm the copter (sticks bottom right/left) but nothing is happening.
I also have another hexacopter which is running perfect with another Naza-M v2, with the same settings. This copter is configured with the same computer/assistant software.
Any ideas on whats wrong?