Lightbridge video link to tablet problem - 2 operator setup

M

mello

Member
Getting bad scrabbled video from the LB to an android tablet. All firmware is up to date. We are running a 2 operator setup which includes - two 2.4 radio TX, one 5.8 FPV system, one lightbridge system and the copter is using the A2 flight controller. The video appears to have interference and sometimes goes completely black. Is the 2nd 2.4 TX and RX causing this? We had no problems with the HTMI port on the LB. This problem started when we attempted to use the tablet…either iPad or Android…still, really bad scrabbled video.
Any help would be greatly appreciated.
 


M

mello

Member
We had the pilot camera connected to the LB with the hdmi port and it worked fine with the two 2.4 radios. The hdmi port broke and now we are attempting to use the usb port for the pilot camera to view the video link with a tablet and thats when the problem started.
 

M

mello

Member
Maybe I'm not clear enough with my question?



We have a lightbridge trying to supply the RC control and FPV for the pilot. The camera operator has a 2.4 radio with matching 2.4 transmitter for RC control of the gimbal…the camera op is using a 5.8 fpv setup to view the camera.



The problem…we are using the usb out of lightbridge to connect a tablet so the pilot can see the fpv camera. The sign is scrambled and broken.



Any ideas?

thnx for any help
 

T

Tahoe Ed

Active Member
Change the 2.4gHz camera Tx for a 5.8. Make sure that the android tablet has wifi and bluetooth turn off and the RC tx's have RF turned off.
 

You must log in or register to reply here.
Top