Help!!!!!!!!!!

B

bernie123

Member
I am completely new to this, so please bear with me. I have the DJI phantom 1 with the GoPro mount. I accidentally severed one of the antennas from the inside receiver board. I accidentally ordered one made for the DJI phantom 2/vision + and i am wondering if i can somehow manage to bind this receiver board to my transmitter, or if it is a lost cause. Part two of this post is me wondering if i can bind the other receiver i ordered. Hers the story: i opened up my phantom, and i removed the board with the broken antenna (antenna 1 of 2 that was broken) and i noticed that 2 plugs plugged into my previous board, but the board i received "made for the phantom 1" only had one plug thing. i tried to follow the steps on a youtube channel, as well as a step by step process of binding the new receiver to the original transmitter, but it just wouldn't go. Does anyone have a process that i have just not learned about on how to bind either of these boards to the transmitter?

Thanks so much,
Bernie
 

C

cootertwo

Member
I believe you're dealing with 2 different frequencies. Phantom 2 vision receiver will require a Phantom 2 vision radio.
 







FlyGirl

FlyGirl

Member
I wish I could help but I don't own one.... There are several YouTube videos on how to open the case and I would imagine there is just a couple of screws holding the receiver board in. And since there are only two cables that should be easy as well.
 



You must log in or register to reply here.
Top