hello .. i think i have a problem with my naza

[guy1a]

i have a hexa frame with naza fc using motors and esc not from dji

when flying in att mode of in gps mode .. i have no problems and everything is fine.
but when trying to fly in manual mode .. as soon as the flash red light of 1st low batt alert starts. the mrc become non controllable.
i mean if in mid air, it falls. if on ground it can't take off.
as if the gyros are not working.

did any one hear of anything like that ?

thank you

 

[kloner]

did you calibrate the esc's to your throttle out on the receiver? each one at a time?

 

[guy1a]

did you calibrate the esc's to your throttle out on the receiver? each one at a time?

Hi.
Thanks for the answer.
I think i did .. but i can redo ..
Will do .. and check again.

Sent from my GT-I9100 using Tapatalk 2

 

[guy1a]

Ok .. re calibarate all esc and tried again.

I come to think the problem is differrnt.

It lloks lije my motors are not strong enough.

When one arm is fallong i need to compansate with a lot of cyclic to the other side.

I thought it was a problem with naza...

I reset a new expo & d/r conf when in manual and it looks lije it is controlable now ...

How can i telk if my motors are not enough ?

Thanjs.

Sent from my GT-I9100 using Tapatalk 2

 

[kloner]

naza doesn't do well with dual rates, i'd use expo if you need a softer feel.....

 

[Bowley]

I have recently had a similar problem, 10 seconds into flight, first red flash and lose sufficient power to maintain control and oscillates down to heavy landing.
This only happens when I use 1 particular battery and every time I use that battery. the battery when I check it reads almost a full charge,, wierd, must be a faulty cell.
Does yours do it with all your batteries?

 

[guy1a]

I have recently had a similar problem, 10 seconds into flight, first red flash and lose sufficient power to maintain control and oscillates down to heavy landing.
This only happens when I use 1 particular battery and every time I use that battery. the battery when I check it reads almost a full charge,, wierd, must be a faulty cell.
Does yours do it with all your batteries?

Yes ... but .. red flash comes when batterys are empty .. 7/10 min.

Sent from my GT-I9100 using Tapatalk 2