Fatshark attitude TX on 4s (which BEC?)

R

Rehost

Member
Hey guys,

I'm going into FPV and decided to get the Attitudes. Problem is I run 4s batteries. From what I'm reading Hobbyking BECs are noisy for transmitters. Some suggest running off 3 cells via the balance port but that doesn't seem right IMO.

What do you guys recommend I do?

Thanks!
Dan
 

kloner

kloner

Aerial DP
if this is a normal immersion looking fatshark vtx it runs from 6-16 volts and can go straight to a 4s flight pack
 


kloner

kloner

Aerial DP
yea, thats a different deal, get this one

http://www.dpcav.com/xcart/Adjustable-Voltage-Regulator-1-35V-Step-Down.html

if you wanna save money get this one

http://www.ebay.com/itm/250954117473?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

that exact auction ended, but scroll down and see if he has a new auction. There actually nicer than the dpcav ones, you can get a few of those with ems shipping as cheap as 1 from dpcav. Both are in alot of my stuff. There only good for a few watts of power like a vtx and camera, don't try it with a servo, they run a flight controller , rc receiver and a band of esc's like a normal multi rotor good. You can bury it too, doesn't get very hot like it needs to sit in prop wash. in planes i gorilla glue em in like insulated and they've never caused any problems
 



You must log in or register to reply here.
Top