hei guys,
i'm a newbie in this forum. I was searching if anyone had similar problem with the DJI esc 30A.
I had my DJI Naza F450 completed built last week and had a couple of easy flights, i must say i love this machine already.
But today when ready for another flight, the motor1 sputters and i later determined it was problem with the esc1.
When i connected motor1 to esc2, motor1 works fine. Then when i connected esc2 to port M1 on main control unit, the esc2 and motor also run ok.
So i figured the problem must be with esc1.
Had anyone seen this problem? especially since the esc has had only 2 flights (about 8 minutes each).
Would appreciate any suggestion how to check if the esc is really damaged.
Thanks
-nik
i'm a newbie in this forum. I was searching if anyone had similar problem with the DJI esc 30A.
I had my DJI Naza F450 completed built last week and had a couple of easy flights, i must say i love this machine already.
But today when ready for another flight, the motor1 sputters and i later determined it was problem with the esc1.
When i connected motor1 to esc2, motor1 works fine. Then when i connected esc2 to port M1 on main control unit, the esc2 and motor also run ok.
So i figured the problem must be with esc1.
Had anyone seen this problem? especially since the esc has had only 2 flights (about 8 minutes each).
Would appreciate any suggestion how to check if the esc is really damaged.
Thanks
-nik