DJI OSD not displaying output from a Pixim Seawolf FPV camera

[RotorTalk]

Tested this with both my Pixim's as best I can and have come to the conclusion the DJI OSD won't work with them. Could it be the resolution is too high? (750 lines) or could it be a GND issue? (I've run separate 12V power to the camera; and GND plus signal to the OSD) OSD is working fine with A/V out from a Canon G11 on both AV channels. Both cams work fine if I leave the OSD out.

 

[kloner]

holly smokes

So all cams have to have a video feed and ground coming from them to the osd. Theres no way around it. where it gets power doesn't matter as long as that happens and dual pack setups might need a common ground. I'd do it with regulated power supplies if it was mine, then ground is the same trhoughout without a bunch of trial and error. did you try powering the cam from zenmeuse? 11.2 not enough to boot it?

 

[RotorTalk]

DJI just emailed to say they acknowledge there's a problem with AV-in on particular FPV cameras and are working on it. They promise a solution 'soon'.

 

[RotorTalk]

Works fine with GoPro Hero 2...

Distance only shows after take-off.

GPS Mode only confirmed after 5 SAT Lock

On first view I'd say the attitude indicator is too coarse for AP but OK for aerobatics ?!