Dji Naza going crazy

[hjls3]

Kloner is much more experienced than I, wondering though if your props are unbalanced? I also chased a similar problem and eventually changed a motor bearing out and wala, that was it. I am pretty new to all this stuff and I have sort of figured out that lots of things can make a MR fly like the gains are too high. Checking the props is so easy its worth doing if you havent. Best of luck.

 

[kloner]

those motors with the built in prop adapters start causing problems too as you crash you way through learning. any moarks usually makes it not accelerate/decellerate as well as it did. same with dings in the props

 

[hover]

I tested all four motors yesterday. The shaft and bearings are all ok, I touched the motors on the bottom side to feel the vibrations and they were zero. Also the propellers spin great.

My Naza flys good at 130 and this should be enough. Only at 120% with Graupners and <100% with Dji propellers the quadrocopter acts strange.