D8R-XP connection to Naza Lite via SBUS

[AZflyer]

New to multirotor and at a standstill with my build. Does anyone know how to connect the D8R-XP via SBUS (FrSky SBUS) to a NAZA Lite with GPS? The build list is:
xHover MXP 230 frame, SunnySky 2300Kv motors, 12A ESC SimmonK flashed, D8R-XP rx, NAZA Lite with GPS, Sony 600 FPV camera, Boscam 600 FPV tx, Minim OSD, Turnigy er9X with DJT module and Smartie parts board flashed wit eer. Thank you for looking.

 

[kloner]

if it's sbuss follow the sbus connection section of the naza manual..... it involves putting it in a certain pin and changing the software in assistant to match

 

[AZflyer]

Thank you, I have been following the manual but that is where the confusion comes in. I have been unsuccessful in determining if the FrSky D8R-XP is a JR type or a Futaba Type. Not sure if that makes a difference in SBUS connection but it seems to matter in the setup. Between the two (D8R-XP and NAZA) I have inserted the FrSky SBUS to CPPM module. I have jumped the signal pins 3 and 4 and connected the SBUS module to position 1 of the D8R-XP and plugged the other end (CPPM Out) to X2 of the NAZA Lite. Thank you for your assistance.