any of you have wk on an osd?

[kloner]

i'm curious to what it draws sitting still? this thing i just hooked up draws 2.7 static, and i got the wk's vu or whatever you guys call it before the sensor...... this things being strange,,,,, wk doesn't draw off the dji opto esc's does it? been a long time since i had lights never seen a wookong lit up so i'm just trying to feel my way along.... 2.7 amps seems like a lot


heres mine on the tbs rig

and that's with a gimble servo

 

[DaveM]

Hi Kloner,

Can I ask, what is the 2nd voltage readout on your TBS core ?

I only have the furthest top left one displayed on mine, (battery voltage) !


Dave

 

[kloner]

so this is the kicker....... if it gets hot, which someday it will, that comes on and says 5 volt.... it's lettin ya know its hot. Play that tape all the way through, think it's 7.9ish or so it starts tearing, sooner or later it'll overheat and shutoff, but i'm told it'll cool fast off and restart.... but yea, it's a primitive osd, if you do it right, it'll get enough air to keep it going down when you fly. i never had a problem till i put that metal shield on the disco..... has great reception though and flying it goes down, but if you sit around before launching, mine do that.

 

[DaveM]

Cheers Kloner,

Thanks for the explanation

I have seen this once on mine when I was trying to set up the RSSI from a
FRSky S-Bus receiver, never did get it working properly.

Are all your Core versions V1.0 ? as another person has got his going with
the FRSky receiver, but he has V1.1, not sure what the difference is.

My core has a green light and a blue light, which I understood to be V1.1,
but when it boots up it displays V1.0


Dave

 

[kloner]

there are 5 of them things in here right now. there is z1.0 and v1.1, the wk in question has a 1.1

 

[DaveM]

I think I may have got mixed up with my version of core :shame:

The core PCB says V1.1 but the when it boots up the graphics show
in top right corner V1.0 in OSD.

Do all the OSD displays show V1.0 ? I thought this was the core version No


Dave

 

[kloner]

this last one says 1.1 on the screen

 

[DaveM]

Thanks Kloner,

I will check with the guy that has his Frsky working, was it V1.1
on the board and on the OSD.

Not sure if I could upgrade the firmware or not, would need to ask
Trappy I suppose.



Dave