A2 Spektrum DSM2 satellite - no stick movements recognized

[UlfG]

I guess this will just be another post in this vast sea of DJI Rx problems.

Hardware:
DJI A2 FW 1.1
2 Spektrum DSM2 satellites
JR PCM9X
Spektrum DSM2 Tx module


Assistant software and LED on flight controller confirm binding is OK (RC link OK). However no stick movements are registered! Anyone seen this?

 

[Droider]

It won't work on 1.1. U need to go to latest FW. Well u can try. Good luck. U may be lucky I wasn't.

 

[UlfG]

Sorry, I was a bit unclear about the FW. It's all the latest:

Controller 2.1
Reciever: 1.1
IMU: 2.1
Led: 2.0
GPS Pro: 2.0
GPS Module: 20.1

What are my options? Buying a Futaba? (According to other threads using the D-bus interface seems to be like asking for a crash)

 

[Droider]

Sorry, I was a bit unclear about the FW. It's all the latest:

Controller 2.1
Reciever: 1.1
IMU: 2.1
Led: 2.0
GPS Pro: 2.0
GPS Module: 20.1

What are my options? Buying a Futaba? (According to other threads using the D-bus interface seems to be like asking for a crash)

Using the A2 is asking for a bloody crash.

 

[Tahoe Ed]

Sorry, I was a bit unclear about the FW. It's all the latest:

Controller 2.1
Reciever: 1.1
IMU: 2.1
Led: 2.0
GPS Pro: 2.0
GPS Module: 20.1

What are my options? Buying a Futaba? (According to other threads using the D-bus interface seems to be like asking for a crash)

I have tested mine A2 with the DSM2 satellites. Did you bind them first to the Tx with a JR or other Rx. I did that first then attached them to that A2. It worked for me. You will only have 9 channels but you can assign them in Assistant. Yes, Futaba works best with DJI but it is not a necessity. I have two JR9503's and a Futaba 8FGS and a 14GS. I like them all.