Search results

True, a little Mercalli is miraculous. Left this untouched on purpose to be able to see how smooth they become at 400 Hz as opposed to the crappy 50 Hz

Hyperion servos are working well at 400 Hz Good enough for me, shot in wide mode so one can see the frame move https://www.youtube.com/watch?v=ogEIY1C5odI

Neither do I - I shot that on purpose in 720 wide so the movement of the frame could be seen :tennis: Normally I use hi-res middle or narrow mode, then it is not visible..

Have a look at http://quadframe.com/collections/frontpage/products/155mmll That together with the GoPro gimbal http://quadframe.com/collections/cm/products/g01k is working fine for me, check this: https://www.youtube.com/watch?v=ogEIY1C5odI

... and make sure to use nylon screws :)

My S-Bus receiver only has one single cable to the FC, I would disconnect all the others ..

Just to make sure, on the R6308SBT only channel 8 can be configured for S-Bus ... Sam

I never have problems with orientation :-D Trex 700 canopy ...

There is no delay, it is realtime. Let me tell you, it is exactly like the real thing, plus I can use my real transmitter with it. Only thing that bothers me that one cannot turn off the auto-level of the various quads - yet. Feature was promised, but that was a while ago.

Maybe have a look at the Aerosim RC simulator - best FVP-Quad-Sim I know and a mere 100 $ .. These 100 $ I will never regret having spent www.aerosimrc.com

Afraid that is the behaviour of the present firmware. Silly little bug if you ask me, since after a "low voltage" landing the motors DO turn off ..

You might try yourself, I did : put Loctite on the hub, wait overnight. Snaps like a wooden stick ... YMMV

!! Do NOT use Loctite (any type of). It is a proven fact that the plastic of the DJI props is cracking as soon as they get in contact with Loctite !! Just tighten the nut by hand using the included tool with reasonable force, don't use excessive force.

In the configuration "autopilot" screen you select which (if any) channel is used to remotely adjust the gains. So when you are satisfied with your gain settings, set all the remote adjust fields to "INH" - which means no channel is used to remotely adjust gains. Probably they are now set to...

No you can't - but there is absolutely no need to anyway ;-)

If your quad goes up fast when you switch ATTI -> MAN, it has a power/weight ratio that is very high. In other words it would probably hover with a throttle way lower than 50 %. While you're in ATTI mode you will not realize that since it is being managed by the brain: 50 % of your stick is...

If you plan on using a camera it will also be easier to avoid having one arm in the picture ;-)

Hi meme I see that your VU blinks fast red when you try to arm. On my NAZA this means "no signal from RX" - as soon as I switch on my TX the red blinks stop. Looks to me like a TX -> RX problem

ESC plugs seem to be plugged in wrong way - signal (white) go to the bottom ..

Only change in 1.4 is that now it supports Y6 configurations